Author:
Wang Zhaoyang,Wu Bing,Huang Jiaqing,Yang Yuqi,Xiao Guangwen
Abstract
Purpose
The purpose of this study is to develop a transient wheel–rail rolling contact model to primarily investigate the rail damage under wet condition when the train passes through the welded joints.
Design/methodology/approach
The impact force induced by welded joints is obtained through vehicle–track coupling dynamics. The normal and tangential wheel–rail contact pressures were solved by elastohydrodynamic lubrication (EHL) theory and simplified third-body layer theory, respectively. Then, the obtained tangential pressure and normal pressure were applied to the finite element model as moving loads, simulating cyclic loading. Finally, the shakedown map and critical plane method were used to predict rolling contact fatigue (RCF) and the initiation of fatigue cracks.
Findings
The results indicate that RCF will occur and fatigue cracks are more prone to appear on the subsurface of the rail, specifically around 2.7 mm below the rail surface in the vicinity of the welded joint and its heat-affected zone.
Originality/value
The cosimulation of numerical model and finite element model was implemented. The influence of surface roughness and fluids was considered. In this model, the normal and tangential wheel–rail contact pressure, the stress and strain and the rail fatigue cracks were obtained under a rail-welded joint excitation.
Subject
Surfaces, Coatings and Films,General Energy,Mechanical Engineering
Reference26 articles.
1. Numerical investigation of crack initiation in rails and wheels affected by martensite spots;International Journal of Fatigue,2018
2. Analysis of adhesion under wet conditions for three-dimensional contact considering surface roughness;Wear,2005
3. The development of a crack propagation model for railway wheels and rails;Fatigue & Fracture of Engineering Materials & Structures,2015
4. Contact characteristics of a rolling/sliding cylinder and a viscoelastic layer bonded to an elastic substrate;Wear,1995
5. The effect of track and vehicle parameters on wheel/rail vertical dynamic loads;Railway Engineering Journal,1974