The structure of a turbulent shear layer bounding a separation region

Abstract

Detailed measurements within the separated shear layer behind a flat plate normal to an airflow are reported. A long, central splitter plate in the wake prevented vortex shedding and led to an extensive region of separated flow with mean reattachment some ten plate heights downstream. The Reynolds number based on plate height was in excess of 2 × 1044.Extensive use of pulsed-wire anemometry allowed measurements of all the Reynolds stresses throughout the flow, along with some velocity autocorrelations and integral timescale data. The latter help to substantiate the results of other workers obtained in separated flows of related geometry, particularly in the identification of a very low-frequency motion with a timescale much longer than that associated with the large eddies in the shear layer. Wall-skin-friction measurements are consistent with the few similar data previously published and indicate that the thin boundary layer developing beneath the separated region has some ‘laminar-like’ features.The Reynolds-stress measurements demonstrate that the turbulence structure of the separated shear layer differs from that of a plane mixing layer between two streams in a number of ways. In particular, the normal stresses all rise monotonically as reattachment is approached, are always considerably higher than the plane layer values and develop in quite different ways. Flow similarity is not a useful concept. A major conclusion is that any effects of stabilizing streamline curvature are weak compared with the effects of the re-entrainment at the low-velocity edge of the shear layer of turbulent fluid returned around reattachment. It is argued that the general features of the flow are likely to be similar to those that occur in a wide range of complex turbulent flows dominated by a shear layer bounding a large-scale recirculating region.