Author:
Steffan K.-E. W. H.,Fett M.,Kirchner E.
Abstract
AbstractIn modular products conflicting objectives may occur. This leads to characteristics as component-dependent oversizing and undersizing as well as increased complexity of the interfaces. These conflicts can be resolved using the potentials of AM processes. For the best use possible, the potentials are systematically considered in the early design phases as part of an extended procedure. The extended procedure improves the benefit-effort ratio of modular respectively individual products and a further optimization of the product architecture and consideration of synergy effects is achieved.
Publisher
Cambridge University Press (CUP)
Reference32 articles.
1. Göpfert, J. and Steinbrecher, M. (2000), “Modulare Produktentwicklung leistet mehr”, Harvard Business Manager, Vol. 3, pp. 20–31.
2. Decision trees for implementing rapid manufacturing for mass customisation
3. The status, challenges, and future of additive manufacturing in engineering
4. Process Types of Customisation and Personalisation in Design for Additive Manufacturing Applied to Vascular Models
5. Shoei (2019), X-Fourteen-X-Spirit III Manual. [online] Shoei co. ltd. Available at: www.shoei-europe.com/upload/manuals/X-Fourteen-X-Spirit_III_100P-small.pdf (accessed 05.11.2019)
Cited by
5 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献