Author:
Zisopol D. G.,Nae I.,Portoaca A. I.
Abstract
In this research, two polymeric materials, PLA-(polylactic acid) and ABS (acrylonitrile butadiene styrene) were used to 3D print compression samples at 3 layer heights (0.10, 0.15, and 0.20mm) with 3 infill percentages (50%, 75%, 100%). In order to determine the material's behavior under applied crushing loads, 135 samples were fabricated and tested. The built compression PLA specimens were subjected to common annealing treatment just above glass transition temperature and it was proved that the set of 45 samples exhibited higher resistance to the compressive load applied to the material before fracturing by an average of 9.20%.
Publisher
Engineering, Technology & Applied Science Research
Cited by
8 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献