Forming Limit Diagram Prediction of Tailor-Welded Blank Using Experimental and Numerical Methods-Reference-Cited by-同舟云学术

Forming Limit Diagram Prediction of Tailor-Welded Blank Using Experimental and Numerical Methods

Published:2012-02-10 Issue:10 Volume:21 Page:2053-2061
ISSN:1059-9495
Container-title:Journal of Materials Engineering and Performance
language:en
Short-container-title:J. of Materi Eng and Perform

Author:

Safdarian Korouyeh Rasoul,Moslemi Naeini Hassan,Liaghat Gholamhosein

Publisher

Springer Science and Business Media LLC

Subject

Mechanical Engineering,Mechanics of Materials,General Materials Science

Link

http://link.springer.com/content/pdf/10.1007/s11665-012-0156-9.pdf

Reference26 articles.

1. Z.Q. Sheng, Formability of Tailor-Welded Strips and Progressive Forming Test, J. Mater. Process. Technol., 2008, 205, p 81–88

2. S.P. Keeler and W.A. Backofen, Plastic Instability and Fracture in Sheets Stretched Over Rigid Punches, Trans. ASM, 1963, 56, p 25–48

3. G.M. Goodwin, Application of Strain Analysis to Sheet Metal Forming Problems in the Press Shop. SAE paper, 1968. Paper No.680093

4. S.S. Hecker, A Simple Forming Limit Curve Technique and Results on Aluminum Alloys, Sheet Metal Forming And Formability, Proceedings of the 7th Biennial Congress of the International Deep Drawing Research Group, Amsterdam, 1972, p 5.1–5.8

5. Z. Marciniak and K. Kuczynski, Limit Strains in the Processes of Stretch-Forming Sheet Metal, Int. J. Mech. Sci., 1967, 9, p 609–620

Cited by 22 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Study of single point incremental forming limits of Al 1050/Mg-AZ31B two-layer sheets fabricated by roll bonding technique: Finite element simulation and experiment;Journal of Materials Research and Technology;2024-03

2. Experimental and Numerical Investigation of Forming Limit Diagrams during Single Point Incremental Forming for Al/Cu Bimetallic Sheets;Metals;2024-02-09

3. Investigation of over-bending defect in the cold roll forming of U-channel section using experimental and numerical methods;Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture;2022-03-01

4. Finite element simulations and experimental verifications for forming limit curve determination of two-layer aluminum/brass sheets considering the incremental forming process;Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications;2021-10-12

5. Influence of Notch Radius and Thickness on Fracture Mechanisms of Al6061-T6 Plate Specimens;Transactions of the Korean Society of Mechanical Engineers - A;2021-03-31