No kinematical difference between ultra-congruent and medial-congruent total knee arthroplasty when implanted with mechanical alignment: an in vivo dynamic RSA study

Abstract

Abstract Purpose To explore in vivo kinematical behavior of the same total knee arthroplasty (TKA) cruciate-retaining (CR) femoral design with either medial-congruent (MC) or ultra-congruent (UC) inlay using model-based dynamic radiostereometric analysis (RSA). The hypothesis was that there would be comparable kinematics between the two groups. Methods A cohort of 16 randomly selected patients (8 MC Persona Zimmer, 8 UC Persona Zimmer) was evaluated through dynamic radiostereometric analysis (RSA) at a minimum of 9 months after TKA, during the execution of a sit-to-stand. The antero-posterior (AP) translation of the femoral component and the AP translation of the low point of medial and lateral femoral compartments were compared through Student’s t test (p < 0.05). Results Both groups showed a medial pivot behavior, with a significantly greater anterior translation of the Low Point of the lateral compartment with respect to the medial compartment (MC medial range: 2.4 ± 2.4 mm; MC lateral range: 7.7 ± 3.0 mm; p < 0.001 – UC medial range: 3.3 ± 3.3 mm; UC lateral range: 8.0 ± 3.2 mm; p < 0.001). A statistically significant greater degree of flexion was clinically recorded at follow-up visit in the MC group respect to the UC group (126° vs 101°—p = 0.003). Conclusion The present study did not show difference in the medial pivot behavior between ultra-congruent and medial-congruent total knee arthroplasty when implanted with mechanical alignment; however, the MC group demonstrated a greater degree of flexion. The MC design examined is a valid alternative to the UC design, allowing to achieve a screw-home movement restoration combined with a high flexion. Level of evidence IV.