Abstract
AbstractIn the paper, results of a research on braze welded joints of copper-lined 10CrMo9-10 (10H2M) steel tubes made by CMT arc braze welding are presented. As a filler metal, silicon bronze was applied. Results of metallographic examinations with the use of light microscopy, electron scanning microscopy and X-ray microanalysis are presented. Mechanical properties of the joints were assessed on the grounds of static tensile test, technological bending test, as well as hardness measurements. Quality of the obtained joints was good. No cracks were observed in the brazed joints and the obtained mechanical properties were satisfactory.
Publisher
Springer Science and Business Media LLC
Subject
Mechanical Engineering,Civil and Structural Engineering
Reference19 articles.
1. Shiri SG, Nazarzadeh M, Sharifitabar M, Afarani MS. Gas tungsten arc welding of CP-copper to 304 stainless steel using different filler materials. Trans Nonferrous Met Soc China. 2012;22:937–2942.
2. Magnabosco I, Ferro P, Bonollo F, Arnberg L. An investigation of fusion zone microstructures in electron beam welding of copper–stainless steel. Mater Sci Eng A. 2006;424:163–73.
3. Kuryntsev SV, Morushkin AE, Kh Gilmutdinoy A. Fiber laser welding of austenitic steel and commercially pure copper butt joint. Opt Lasers Eng. 2017;90:101–9.
4. Sabharwall P, Clark DE, Mizia RE, Glazoff MV, Mckellar MG. Diffusion-welded microchannel heat exchanger for industrial processes. J Therm Sci Eng Appl. 2013. https://doi.org/10.1115/1.4007578.
5. Mirski Z, Granat K, Prasałek A. The diffusive barriers in copper brazing with austenitic steel by use the Cu–Ag–P (L-Ag15P) filler metal. Arch Metall Mater. 2008;53:1035–46.
Cited by
1 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献