UAV Airframe Topology Optimization-Reference-Cited by-同舟云学术

UAV Airframe Topology Optimization

Published:2021 Issue: Volume: Page:338-346
ISSN:2195-4356
Container-title:Lecture Notes in Mechanical Engineering
language:
Short-container-title:

Author:

Martinez Leon A. S.,Rukavitsyn A. N.,Jatsun S. F.

Publisher

Springer International Publishing

Link

http://link.springer.com/content/pdf/10.1007/978-3-030-54814-8_41

Reference20 articles.

1. Emelyanova OV et al (2017) The synthesis of electric drives characteristics of the UAV of “convertiplane-tricopter” type. In: MATEC web of conferences, vol 99. https://doi.org/10.1051/matecconf/20179902002

2. Jatsun S, Emelyanova O, Martinez Leon AS (2020). Design of an experimental test bench for a UAV type convertiplane. IOP Conf Ser Mater Sci Eng 714. https://doi.org/10.1088/1757-899x/714/1/012009

3. Jatsun S et al (2020) Investigation of oscillations of a quadcopter convertiplane in transient mode in the vertical longitudinal plane. In: Proceedings of 14th international conference on electromechanics and robotics “Zavalishin’s Readings”, Springer, Singapore, pp 345–358

4. Goraj Z (2005) Design challenges associated with development of a new generation UAV. Aircr Eng Aerosp Technol 77(5):361–368

5. Alphonso RF, Irawan AP, Daywin FJ (2015) Design and development of quadcopter prototype. In: 2nd International conference on engineering of Tarumanagara

Cited by 10 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Influence of inertia relief analysis on the topological optimisation of unconstrained structures;International Journal on Interactive Design and Manufacturing (IJIDeM);2024-08-29

2. Drones in E-Commerce;Advances in Computational Intelligence and Robotics;2024-05-31

3. Topology optimization and 3D printing of a unibody quadcopter airframe;IOP Conference Series: Materials Science and Engineering;2024-04-01

4. Optimization of Monocoque Drone Frame Using Generative Design;2024 International Conference on Image Processing and Robotics (ICIPRoB);2024-03-09

5. A Review of Topology Optimisation Software for Additive Manufacturing: Capability Comparison;2023 15th IEEE International Conference on Industry Applications (INDUSCON);2023-11-22