Optimization of wire-cut EDM parameters using Taguchi and entropy coupled COPRAS approach for machining of CRT glass powder reinforced magnesium surface composite developed using friction stir processing-Reference-Cited by-同舟云学术

Optimization of wire-cut EDM parameters using Taguchi and entropy coupled COPRAS approach for machining of CRT glass powder reinforced magnesium surface composite developed using friction stir processing

Published:2024-01-14 Issue: Volume: Page:
ISSN:1955-2513
Container-title:International Journal on Interactive Design and Manufacturing (IJIDeM)
language:en
Short-container-title:Int J Interact Des Manuf

Author:

Gopal P. M.^ORCID,Kavimani V.,Sudhagar S.,Sonar Tushar,Venkatesh S.

Publisher

Springer Science and Business Media LLC

Link

https://link.springer.com/content/pdf/10.1007/s12008-023-01705-x.pdf

Reference30 articles.

1. Mehr, F.R., Salavati, M., Morgenthal, A., Kamrani, S., Fleck, C.: Computational analysis and experimental calibration of cold isostatic compaction of Mg-SiC nanocomposite powders. Mater Today Commun 27, 102321 (2021)

2. Mahdy, A.A.: Fabrication and characterizations of Mg/SiC composite via compo-casting technique. J Am Sci 10, 196–202 (2014)

3. Sudhagar, S., Gopal, P.M.: Investigation on mechanical and tribological characteristics Cu/Si 3 N 4 surface composite developed through friction stir processing. Silicon 14, 1–10 (2022)

4. Ma, Z.Y., Mishra, R.S., Mahoney, M.W., Grimes, R.: High strain rate superplasticity in friction stir processed Al–Mg–Zr alloy. Mater. Sci. Eng. A 351, 148–153 (2003)

5. Palko, W.A., Fielder, R.S., Young, P.F.: Investigation of the use of friction stir processing to repair and locally enhance the properties of large Ni Al bronze propellers. Mater. Sci. Forum 426, 2909–14 (2003)

Cited by 3 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Experimental examination on electrochemical micro-machining of Mg–Li–Sr biomedical alloy: Application of ANOVA, Deng’s similarity, and ANFIS for effective modeling optimization;AIP Advances;2024-09-01

2. Optimization of WEDM of Inconel 625 by employing MABAC, MARKOS and PIV practices: a comparative study;International Journal on Interactive Design and Manufacturing (IJIDeM);2024-08-26

3. Optimization of WEDM parameters for machining Mg-Li-RE alloy using CRITIC-COCOSO approach;International Journal on Interactive Design and Manufacturing (IJIDeM);2024-06-12