Fundamental Research on Hobbing with Minimal Quantity Lubrication of Cutting Oil-Reference-Cited by-同舟云学术

Fundamental Research on Hobbing with Minimal Quantity Lubrication of Cutting Oil

Published:2006 Issue:2 Volume:49 Page:590-599
ISSN:1344-7653
Container-title:JSME International Journal Series C
language:en
Short-container-title:JSME Int. J., Ser. C

Author:

MATSUOKA Hironori¹,SUDA Satoshi²,YOKOTA Hideo²,TSUDA Yoshihiro¹

Affiliation:

1. Department of Mechanical and Energy Systems Engineering, Oita University

2. Nippon Oil Corporation

Publisher

Japan Society of Mechanical Engineers

Subject

Industrial and Manufacturing Engineering,Mechanical Engineering

Link

http://www.jstage.jst.go.jp/article/jsmec/49/2/49_2_590/_pdf

Reference20 articles.

1. Dry Cutting

2. (2) Matsubara, T., Eco-Machining Technology, Prepr. of Jpn. Soc. Precision Eng., 2001 Great Spring Meeting, (in Japanese), March, (2001), p.80.

3. (5) Suda, S., Yokota, H., Komatsu, F., Inasaki, I. and Wakabayashi, T., Evaluation of Machinability with MQL System and Effectiveness in Production Lines, Proc. of the International Tribology Conference, Nagasaki, 2000, (2000), pp.230-235.

Cited by 6 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Mathematical model describing the course of the process of wear of a hob cutter for various methods of cutting fluid supply;Ekspolatacja i Niezawodnosc - Maintenance and Reliability;2016-01-01

2. INFLUENCE OF AXIAL FEED IN HOBBING WITH MINIMAL QUANTITY LUBRICATION (MQL) ON WEAR OF THE HOB AND CUTTING FORCES;Scientific Journal of Silesian University of Technology. Series Transport;2015-12-01

3. Evaluation of the convective heat transfer coefficient for minimum quantity lubrication (MQL);Industrial Lubrication and Tribology;2012-09-21

4. Fundamental Research on Hobbing with Minimal Quantity Lubrication of Cutting Oil (Effect of Fullerene Additive);TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C;2012

5. Distribution Ratio of Hob Wear in Cutting Process of Chip;Journal of the Japan Society for Precision Engineering;2010