Abstract
During the construction of a section of the S-7 Lubień – Rabka-Zdrój dual expressway, located in the area of the Carpathian flysch (Carpathian Flysch Belt, South Poland), damage to the embankment was observed, as well as cracks and depressions in the new pavement. An analysis of the geological and engineering conditions in the area of the road section under construction showed the existence of a complex tectonic structure of the flysch formations, a shallow groundwater table, and numerous landslides. In order to stabilize the road substrate, it was decided to carry out injections, and the locations of these injections were initially geotechnically tested. However, due to the high variability of the geological structure, the target method employed was electrical resistivity tomography (ERT), which performed the survey in two stages. In Stage I, the geoelectrical/geochemical structure of the near-surface zone was identified, and the probable causes of road damage were indicated. This stage was completed by performing the stabilization and sealing process of the ground with an injection mixture. In Stage II, studies were carried out to evaluate the effectiveness of the injection process. The ERT method effectively identified the shallow geological structure and, in particular, delineated the zone of strong fractures in the flysch and areas associated with faults. Using the electrical resistivity tomography method, it was also possible to determine the injection mixture’s approximate penetration depth and the loosening zone’s degree of filling.
Publisher
AGHU University of Science and Technology Press
Subject
General Earth and Planetary Sciences,General Environmental Science