How Combined Cycle Configuration is Impacted by Current Power Market Requirements

Abstract

In the past 20 years, the equipment manufacturers have made significant strives to develop better and more cost effective products: gas turbines, steam turbines, Heat Recovery Steam Generators (HRSG), water treatment, fuel treatment equipment etc. Consequently, the Combined Cycle Power Plants (CCPP) have become, due to many technological breakthroughs, the most efficient form of electrical power generation from fossil fuel, reaching or exceeding net efficiencies of 60%. We are also witnessing a substantial penetration of Renewable in the power generation mix. The Renewable intermittent nature of generation associated with new grid requirements for spinning reserves and/or frequency control must be considered when new CCPP are conceptually designed. The paper will examine several CCPP configurations, involving one, two, and three gas turbines. Substantial improvements in the efficiency are usually associated with an increased gas turbines electrical output. Various scenarios of plant configurations with targeted, sensible level of integration will be examined. The challenges of major equipment selection (gas turbines, heat recovery steam generator steam turbines, heat sink) for each of the configurations will be examined from an EPC (Engineering, Procurement, Construction) Contractor perspective, based on the lessons learned from the development and execution of more than 30 advanced CCPPs. A special emphasis will be given to the strategy of providing the CCPP with fast start-up, capability, rapid load changes, without negatively impacting part-load efficiencies and emissions. The effect of plant configuration on plant reliability, maintenance requirements and recommended spare parts will also be discussed. Finally the paper describes the lessons learned, in plant configuration selection that can be successfully employed on future projects through judicious equipment selection at the development phase, design optimization and proper project management at the execution phase.