Affiliation:
1. Center for Robotics and Manufacturing Systems, University of Kentucky, Lexington, KY 40506-0108
2. Department of Mechanical Engineering, Louisiana State University, Baton Rouge, LA 70803
Abstract
A pin-on-disk tribometer was used to investigate the influence of several parameters on the sliding friction coefficient between hard and deformable surfaces. Pin (1045 tool steel) and disk (aluminum 1100) were utilized to simulate the interaction of a harder tool sliding relative to a softer deformable workpiece. Friction coefficient results were obtained at 561 distinct operating conditions by varying the ball diameter (3.18, 6.35, and 12.70 mm), lubricant (oil B, oil A, and grease), sliding speed (0.1∼0.8 m/s) and normal load (50∼1200 g). Several relationships which characterize the behavior of the friction coefficient as a function of the shear factor, τk, are established. the importance of these relationships, as related to stamping and forming processes, is discussed. [S0742-4787(00)01703-3]
Subject
Surfaces, Coatings and Films,Surfaces and Interfaces,Mechanical Engineering,Mechanics of Materials
Reference28 articles.
1. Wilson, W. R. D.
, 1988, “Friction Models for Metal Forming in the Boundary Lubrication Regime,” ASME J. Eng. Mater. Technol., 113, pp. 60–68.
2. Dong, Y., Tagavi, K. A., and Lovell, M. R., 1999, “Analysis of Interfacial Slip In Cross Wedge Rolling: A Numerical and Phenomenological Investigation,” accepted for publication in J. Mater. Process. Technol.
3. Bowden, F. P., and Tabor, D., 1942, “Mechanism of Metallic Friction,” Nature (London), 150, pp. 197–199.
4. McFarlane, J. S., and Tabor, D., 1950, “Junction Growth in Metallic Crystals,” Proc. R. Soc. London, Ser. A, 202, pp. 244–253.
5. Challen, J. M., and Oxley, P. L. B., 1979, “An Explanation of the Different Regimes of Friction and Wear Using Asperity Deformation Models,” Wear, 53, pp. 229–243.
Cited by
21 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献