Method for Calculating Plastic Deformation of High Resolution and Large Contact Area

Abstract

Abstract In a rolling contact, the tribological properties in terms of friction, wear, and fatigue are significantly influenced by the surface roughness. Due to solid contact of the surfaces in the contact area, the roughness and thus also the tribological properties change during the service life of the contact. The initial load leads to major changes of the tribological properties figured out by Brecher et al. (2019, “Influence of the Metalworking Fluid on the Micropitting Wear of Gears,” Wear, 61(434–435), p. 202996). Prediction of the initial changes in topography in the contact area is necessary for specific optimization of rolling contacts. Especially for dry rolling–sliding contact, the roughness of the surfaces is crucial for the lifetime, which is part of the investigations within the DFG priority program 2074 (357505886). In this work, an elastic-plastic contact algorithm for calculating plastic deformation for dry contact of rough surfaces with large contact area and high resolution is presented. Due to the nonlinearity behavior associated with plastic deformation, the plastic contact algorithm is based on an iterative approach. An optimized meshing strategy is implemented to calculate the elastic pressure distribution on the surface. Corresponding to the two-dimensional pressure distribution, the three-dimensional stress distribution allows the consideration of residual stresses and interactions of the microscopic peaks of the rough surface. Furthermore, the three-dimensional plastic strain distribution allows the application of an analytical approach to represent the plastic deformation of the surface. Finally, the solution of a plastic contact calculation with an exemplary topography measured on a real rough surface is presented.