Anisotropy of Cu-Based Shape Memory Alloys In Tension/Compression Thermomechanical Loads-Reference-Cited by-同舟云学术

Anisotropy of Cu-Based Shape Memory Alloys In Tension/Compression Thermomechanical Loads

Published:1999-01-01 Issue:1 Volume:121 Page:48-55
ISSN:0094-4289
Container-title:Journal of Engineering Materials and Technology
language:en
Short-container-title:

Author:

Sˇittner P.¹,Nova´k V.¹

Affiliation:

1. Institute of Physics, Academy of Sciences of the Czech Republic, Na Slovance 2, Prague 8, 182 21 Czech Republic

Abstract

Tension/compression thermomechanical experiments were performed on oriented CuAlNi shape memory alloy single crystals and CuAlZnMn single and polycrystals. Response of the single crystals in thermomechanical loads was strongly anisotropic, dependent on the orientation of the load axis and sense of the load. Tension/compression stress-temperature diagrams were constructed from experimentally determined transformation stresses and temperatures. It was shown that the history dependent strain response of the single crystal in a complex tension/compression thermomechanical cycle could be predicted from the diagram. Thermomechanical behaviors of the CuAlZnMn polycrystal under tension/compression were reported and discussed on the basis of the knowledge of the single crystal anisotropy.

Publisher

ASME International

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science

Link

http://asmedigitalcollection.asme.org/materialstechnology/article-pdf/121/1/48/5879956/48_1.pdf

Reference19 articles.

1. Bhattacharya K. , and KohnR. V., 1996, “Symmetry, Texture and the Recoverable Strain of Shape Memory Polycrystals,” Acta Materialia, Vol. 44, pp. 529–542.

2. Brinson L. C. , and HuangM. S., 1996, “Simplifications and Comparisons of Shape Memory Alloy Constitutive Models,” J. Intell. Mat. Syst. & Struct., Vol. 7, pp. 108–114.

3. Buchheit T. E. , KumpfS. L., and WertJ. A., 1995, “Modelling of the Stress Induced Transformation Behavior of Shape Memory Alloy Single Crystals,” Acta metall. mater., Vol. 43, pp. 4189–4199.

4. Friend C. M. , ManosaL., OrtinJ., and PlanesA., 1991, “A Calorimetric Investigation of Martensitic Transformation Under Applied Stress in Single Crystal CuAlNi Alloys,” Journal de Physique IV, Colloque C4, Vol. 1, pp. 71–76.

5. Horikawa H. , IchinoseS., MoriiK., MizayakiS., and OtsukaK., 1988, “Orientation Dependence of Martensitic Transformation in a CuAlNi Alloy,” Metall. Trans. A, Vol. 19, pp. 915–923.

Cited by 31 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. An Asymmetric Elasto-Plastic Phase-Field Model for Shape Memory Effect, Pseudoelasticity and Thermomechanical Training in Polycrystalline Shape Memory Alloys;Acta Materialia;2020-12

2. Universal Scaling Law for the Size Effect on Superelasticity at the Nanoscale Promotes the Use of Shape‐Memory Alloys in Stretchable Devices;Advanced Electronic Materials;2019-12-08

3. Cross Hardening of a Shape Memory Alloy during Compression;Russian Metallurgy (Metally);2019-10

4. Experimental Identification of a Nonlinear Deformation Model for a Shape Memory Alloy during Phase and Structural Transformations;Russian Metallurgy (Metally);2019-04

5. Plastic flow resistance of NiTiCu shape memory alloy-theory and experiments;Acta Materialia;2019-01