Impact Responses of the Flexed Human Knee Using a Deformable Impact Interface
Author:
Atkinson Patrick J.12, Haut Roger C.1
Affiliation:
1. Orthopaedic Biomechanics Laboratories, Michigan State University, East Lansing, MI 48824 2. Department of Mechanical Engineering, Kettering University, Flint, MI 58504
Abstract
Blunt impact trauma to the patellofemoral joint during car accidents, sporting activities, and falls can produce a range of injuries to the knee joint, including gross bone fracture, soft tissue injury, and/or microinjuries to bone and soft tissue. Currently, the only well-established knee injury criterion applies to knee impacts suffered during car accidents. This criterion is based solely on the peak impact load delivered to seated cadavers having a single knee flexion angle. More recent studies, however, suggest that the injury potential, its location, and the characteristics of the damage are also a function of knee flexion angle and the stiffness of the impacting structure. For example, at low flexion angles, fractures of the distal patella are common with a rigid impact interface, while at high flexion angles splitting of the femoral condyles is more evident. Low stiffness impact surfaces have been previously shown to distribute impact loads over the anterior surface of the patella to help mitigate gross and microscopic injuries in the 90 deg flexed knee. The objective of the current study was to determine if a deformable impact interface would just as effectively mitigate gross and microscopic injuries to the knee at various flexion angles. Paired experiments were conducted on contralateral knees of 18 human cadavers at three flexion angles (60, 90, 120 deg). One knee was subjected to a fracture level impact experiment with a rigid impactor, and the opposite knee was impacted with a deformable interface (3.3 MPa crush strength honeycomb material) to the same load. This (deformable) impact interface was effective at mitigating gross bone fractures at approximately 5 kN at all flexion angles, but the frequency of split fracture of the femoral condyles may not have been significantly reduced at 120 deg flexion. On the other hand, this deformable interface was not effective in mitigating microscopic injuries observed for all knee flexion angles. These new data, in concert with the existing literature, suggest the chosen impact interface was not optimal for knee injury protection in that fracture and other minor injuries were still produced. For example, in 18 cadavers a total of 20 gross fractures and 20 subfracture injuries were produced with a rigid interface and 5 gross fractures and 21 subfracture injuries with the deformable interface selected for the current study. Additional studies will be needed to optimize the knee impact interface for protection against gross and microscopic injuries to the knee.
Publisher
ASME International
Subject
Physiology (medical),Biomedical Engineering
Reference32 articles.
1. Spiegler, M.
, 1995, “Knees Have No Warranties,” Amer. Demographics, 17, No. 7, July, pp. 20–21. 2. States, J.
, 1970, “Traumatic Arthritis—A Medical and Legal Dilemma,” Amer. Assoc. for Auto. Med., 14, pp. 21–28. 3. States, J., 1986, “Adult Occupant Injuries of the Lower Limb,” in: Biomechanics and Medical Aspects of Lower Limb Injuries, SAE, Warrendale, PA, pp. 97–107. 4. Fife, D., Ginsburg, M., and Boynton, W., 1984, “The Role of Motor Vehicle Crashes in Causing Certain Injuries,” Public Health, 74, No. 11, pp. 1263–1264. 5. Atkinson, P. J., and Haut, R. C., 1999, “Subfracture Injuries Are Precursors to Gross Fracture in an Experimental Model of Impact Injury in the Human Knee,” Trans. Annu. Meet.—Orthop. Res. Soc., 45.
Cited by
18 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献
|
|