Tipping the Cylinder Block of an Axial-Piston Swash-Plate Type Hydrostatic Machine
-
Published:1997-10-03
Issue:1
Volume:122
Page:216-221
-
ISSN:0022-0434
-
Container-title:Journal of Dynamic Systems, Measurement, and Control
-
language:en
-
Short-container-title:
Affiliation:
1. Mechanical & Aerospace Engineering, University of Missouri—Columbia, Columbia, MO 65211
Abstract
Tipping the cylinder block within an axial-piston swash-plate type hydrostatic machine is a phenomenon that results in a momentary and sometimes permanent failure of the machine since the fluid communication between the cylinder block and the valve plate is instantaneously lost. The efforts of this research are to identify the physical contributors of this phenomenon and to specify certain design guidelines that may be used to prevent the failure of cylinder block tipping. This research begins with the mechanical analysis of the machine and presents a tipping criterion based upon the centroidal location of the force reaction between the cylinder block and the valve plate. This analysis is followed by the derivation of the effective pressurized area within a single piston bore and the cylinder block balance is defined based upon this result. Using standard control volume analysis, the pressure within a single piston bore is examined and it is shown that an approximate pressure profile may be used in place of the more complex representation for this same quantity. Based upon the approximate pressure profile a design criterion is presented which ensures that the pressures within the system never cause the cylinder block to tip. Furthermore, if this criterion is satisfied, it is shown that the worst tipping conditions exist when the system pressures are zero and therefore a criterion governing the design of the cylinder block spring is presented based upon the inertial forces that contribute to the tipping failure. [S0022-0434(00)00901-1]
Publisher
ASME International
Subject
Computer Science Applications,Mechanical Engineering,Instrumentation,Information Systems,Control and Systems Engineering
Reference7 articles.
1. Manring, N., and Johnson, R., 1996, “Modeling and designing a variable-displacement open-loop pump,” ASME J. Dyn. Syst., Meas., Control, 118, pp. 267–271. 2. Schoenau, G., Burton, R., and Kavanagh, G., 1990, “Dynamic Analysis of a Variable Displacement Pump,” ASME J. Dyn. Syst., Meas., Control, 112, pp. 122–132. 3. Kim, S., Cho, H., and Lee, C., 1987, “A Parameter Sensitivity Analysis for the Dynamic Model of a Variable Displacement Axial Piston Pump,” Proceedings of the Institution of Mechanical Engineers, 201, pp. 235–243. 4. Zeiger, G., and Akers, A., 1985, “Torque on the Swashplate of an Axial Piston Pump,” ASME J. Dyn. Syst., Meas., Control, 107, pp. 220–26. 5. Pourmovahed, A.
, 1992, “Uncertainty in the efficiencies of a hydrostatic pump/motor,” Proceedings of the Winter Annual Meeting of the American Society of Mechanical Engineers, Anaheim, CA.
Cited by
33 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献
|
|