Affiliation:
1. School of Mechanical and Production Engineering, Nanyang Technological University, Nanyang Avenue, Singapore 639798
Abstract
Experiments have been performed using water to determine the single-phase forced convection heat transfer from in-line four simulated electronic chips, which are flush-mounted to one wall of a vertical rectangular channel. The effects of the most influential geometric parameters on heat transfer including chip number, and channel height are tested. The channel height is varied over values of 0.5, 0.7, and 1.0 times the heat source length. The heat flux is set at the three values of 5 W/cm2, 10 W/cm2, and 20 W/cm2, and the Reynolds number based on the heat source length ranges from 6 × 102 to 8 × 104. Transition Reynolds numbers are deduced from the heat transfer data. The experimental results indicate that the heat transfer coefficient is affected strongly by the number of chips and the Reynolds number and weakly by the channel height. Finally, the present results from liquid-cooling are compared with other results from air-cooling, and Prandtl number scaling between air and water is investigated.
Subject
Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science
Reference15 articles.
1. Garimella
S. V.
, and EibeckP. A., 1990, “Heat transfer characteristics of an array of protruding elements in single phase forced convection,” Int. J. Heat Mass Transfer, Vol. 33, pp. 2659–2669.
2. Garimella
S. V.
, and EibeckP. A., 1991, “Effect of spanwise spacing on the heat transfer from an array of protruding elements in forced convection,” Int. J. Heat Mass Transfer, Vol. 34, pp. 2427–2430.
3. Garimella
S. V.
, and SchlitzD. J., 1995, “Heat Transfer Enhancement in Narrow Channels Using Two and Three-Dimensional Mixing Devices,” ASME JOURNAL OF HEAT TRANSFER, Vol. 117, pp. 590–596.
4. Gersey, C. O., and Mudawar, I., 1992, “Effects of orientation on critical heat flux from chip arrays during flow boiling,” Advances in Electronic Packaging, Vol. 1, T. C. William and A. Hiroyuki, eds., ASME, New York, pp. 123–134.
5. Gersey
C. O.
, and MudawarI., 1993, “Nucleate Boiling and Critical Heat Flux From Protruded Chip Arrays During Flow Boiling,” ASME Journal of Electronic Packaging, Vol. 115, pp. 78–88.
Cited by
46 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献