Affiliation:
1. Department of Mechanical Engineering, Kum-Oh National University of Technology, Kumi, Kyungbook, Republic of Korea
2. Department of Mechanical Engineering, Seoul National University, Seoul, Republic of Korea
Abstract
Oil-film flow visualizations and three-dimensional flow measurements using a five-hole probe have been conducted to investigate the flow characteristics and aerodynamic loss distributions of film-cooling jets with compound angle orientations. For a fixed inclination angle of the injection hole, measurements are performed at various orientation angles to the direction of the mainstream in the case of three velocity ratios of 0.5, 1.0, and 2.0. Flow visualizations for the velocity ratio of 2.0 show that the increase in the orientation angle furnishes better film coverage on the test surface, but gives rise to large flow disturbances in the mainstream. A near-wall flow model has been proposed based on the surface flow visualizations. It has also been found from the flow measurements that as the orientation angle increases, a pair of count-errotating vortices turn to a single strong one, and the aerodynamic loss field is closely related to the secondary flow. Even in the case of the velocity ratio of 2.0, aerodynamic loss is produced within the jet region when the orientation angle is large. Regardless of the velocity ratio, the mass-averaged aerodynamic loss increases with increasing orientation angle, the effect of which on aerodynamic loss is pronounced when the velocity ratio is large.
Reference15 articles.
1. Cho, H. H., and Goldstein, R. J., 1993, “Heat (Mass) Transfer and Film Cooling Effectiveness With Injection Through Discrete Holes. Part 1: Within Holes and on the Back Surface,” ASME Paper No. 93-WA/HT-58.
2. Goldstein
R. J.
, and ChenH. P., 1985, “Film Cooling on a Gas Turbine Blade Near the End Wall,” ASME JOURNAL OF TURBOMACHINERY, Vol. 107, pp. 117–122.
3. Honami
S.
, ShizawaT., and UchiyamaA., 1994, “Behavior of the Laterally Injected Jet in Film Cooling: Measurements of Surface Temperature and Velocity/Temperature Field Within the Jet,” ASME JOURNAL OF TURBOMACHINERY, Vol. 116, pp. 106–112.
4. Ishii
J.
, and HonamiS., 1986, “A Three-Dimensional Turbulent Detached Flow With a Horseshoe Vortex,” ASME Journal of Engineering for Gas Turbines and Power, Vol. 108, pp. 125–130.
5. ISO 5167-1:1991(E), 1991, “Measurement of Fluid Flow by Means of Pressure Differential Devices—Part 1: Orifice Plates, Nozzles and Venturi Tubes Inserted in Circular Cross-Section Conduits Running Full,” International Organization for Standardization.
Cited by
47 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献