Effects of Temperature on Deep Drawing of Sheet Metals-Reference-Cited by-同舟云学术

Effects of Temperature on Deep Drawing of Sheet Metals

Published:1983-04-01 Issue:2 Volume:105 Page:119-127
ISSN:0094-4289
Container-title:Journal of Engineering Materials and Technology
language:en
Short-container-title:

Author:

Kumpulainen J. O.¹,Ranta-Eskola A. J.¹,Rintamaa R. H. O.²

Affiliation:

1. Helsinki University of Technology, Laboratory of Metal Working and Heat Treatment, SF-02150 ESPOO 15, Finland

2. Technical Research Center of Finland, Metals Laboratory, Metallimiehenkuja 6, SF-02150 ESPOO 15, Finland

Abstract

The influence of temperature on the flow stress and the uniform strain of steel, brass, aluminium and AISI 304 and 316 type stainless steels is determined by using uniaxial tensile tests. Sliding and stretching friction coefficients at several surface temperatures are measured for various sheets and lubricants using a bending under tension type strip drawing test. The validity of the results is verified by deep drawing experiments. The influence of temperature difference between the punch nose region and the flange on the drawing and fracture loads and on the limiting drawing ratio is determined.

Publisher

ASME International

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science

Link

http://asmedigitalcollection.asme.org/materialstechnology/article-pdf/105/2/119/5788649/119_1.pdf

Cited by 14 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Determination of Warm Deep Drawing Behavior of DP590 Steel Using Numerical Modeling and Experimental Process Window;Arabian Journal for Science and Engineering;2021-08-03

2. Comparative study of formability characteristics in deep drawing of DP 590 steel using analytical models;Advances in Materials and Processing Technologies;2021-06-22

3. Deep drawing process at the elevated temperature: A critical review and future research directions;CIRP Journal of Manufacturing Science and Technology;2019-11

4. Advanced Models for the Prediction of Forming Limit Curves;Multiscale Modelling in Sheet Metal Forming;2016

5. Formability of Sheet Metals;Sheet Metal Forming Processes;2010