Affiliation:
1. Research and Development Center, HANJUNG, Korea Heavy Industries and Construction Co., Ltd., 555 Guygok-Dong, Changwon, Kyungnam, 641-792, Korea
Abstract
An experimental study is performed to investigate the frequency effects of the excitation force on the linear stiffness and damping coefficients of a LOP (load on pad) type five-pad tilting pad journal bearing with the diameter of 300.91 mm and the length of 149.80 mm. The main parameter of interest in the present work is excitation frequency to shake the test hearing. The excitation frequency is controlled independently, using orthogonally mounted hydraulic exciters, as follows: 1) excitation frequency ratio in the x-axis direction νx = 0.5, 2) excitation frequency ratio in the y-axis direction νy = 0.6, 0.7, 0.8, 0.9. The magnitude of the excitation force is controlled to make sure that the test hearing has a linear behavior during the test. The relative movement between the bearing and shaft, and the acceleration of the bearing casing are measured as a function of excitation frequency using the different values of bearing load and shaft speed. Measurements show that the variation of excitation, frequency has quite a little effect on both stiffness and damping coefficients. The stiffness coefficients of the five-pad tilting pad journal bearing slightly decrease as the excitation frequency ratio increases, while the damping coefficients slightly increase with excitation frequency ratio, especially in the case of lower speed and higher load. Both direct stiffness and damping coefficients in the direction of bearing load decrease with an increase of shaft speed, but increase with the bearing load.
Subject
Surfaces, Coatings and Films,Surfaces and Interfaces,Mechanical Engineering,Mechanics of Materials
Reference10 articles.
1. Brockwell
K. R.
, KleinbubD., and DmochowokiW., 1990, “Measurement and Calculation of the Dynamic Operating Characteristics of the Five Shoe Tilting Pad Journal Bearing,” STLE Trans., Vol. 33, pp. 481–492.
2. Childs
D.
, ElrodD., and HaleK., 1989, “Annular Honeycomb Seals: Test Results for Leakage and Rotordynamic Coefficients: Comparison to Labyrinth and Smooth Configuration,” ASME JOURNAL OF TRIBOLOGY, Vol. 111, pp. 293–301.
3. Ettles
C. M. M.
, 1980, “The Analysis and Performance of Pivoted Pad Journal Bearings Considering Thermal and Elastic Effects,” ASME JOURNAL OF LUBRICATION TECHNOLOGY, Vol. 102, pp. 182–192.
4. Ha, H. C., Yang, S. H., and Kim, H. J., 1996, “Experimental Study on a Five-Pad Tilting Pad Joumal Bearing Working in Laminar and Turbulent Flow Regions,” Proceedings of ISROMAC-6, pp. 688–694.
5. Knight
J. D.
, and BarretL. E., 1988, “Analysis of Tilting Pad Journal Bearings With Heat Transfer Effects,” ASME JOURNAL OF TRIBOLOGY, Vol. 110, pp. 128–133.
Cited by
40 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献