Affiliation:
1. Nonlinear Phenomena Laboratory, Dept. of Mechanical Engineering and Materials Science, Rice University, Houston, TX 77005
Abstract
Displacement measurement in atomic force microscopy (AFM) is most commonly obtained indirectly by measuring the slope of the AFM probe and applying a calibration factor. Static calibration techniques operate on the assumption that the probe response approximates single mode behavior. For off-resonance excitation or different operating conditions the contribution of higher modes may become significant. In this paper, changes to the calibrated slope-displacement relationship and the corresponding implications on measurement accuracy are investigated. A model is developed and numerical simulations are performed to examine the effect of laser spot position, tip mass, quality factor and excitation frequency on measurement accuracy. Free response conditions and operation under nonlinear tip-sample forces are considered. Results are verified experimentally using a representative macroscale system. A laser spot positioned at a nominal position between x = 0.5 and 0.6 is determined to minimize optical lever measurement error under conditions where the response is dominated by contributions from the first two modes, due to excitation as well as other factors.
Subject
Computer Science Applications,Mechanical Engineering,Instrumentation,Information Systems,Control and Systems Engineering
Reference28 articles.
1. Atomic Force Microscope;Binnig;Phys. Rev. Lett.
2. Atomic Force Microscopy for the Study of Tribology and Adhesion;Meyer;Thin Solid Films
3. Improving Tapping Mode Atomic Force Microscopy With Piezoelectric Cantilevers;Rogers;Ultramicroscopy
4. Self-Sensing and Self-Excited Actuator of Atomic Force Microscopy Probe for Measuring Biological Molecules;Someya;Nippon Kikai Gakkai Ronbunshu C Hen (Trans. Jpn. Soc. Mech. Eng., C) (Japan)
5. Fractured Polymer/Silica Fiber Surface Studied by Tapping Mode Atomic Force Microscopy;Zhong;Surf. Sci.