Affiliation:
1. Department of Mechanical Engineering, University of California, Berkeley, CA 94720
Abstract
Turning experiments were performed with cemented WC-Co cutting tools coated with two-layer and three-layer overcoats of TiC/Al2O3 and TiC/Al2O3/TiN, respectively. For comparison, uncoated WC-Co tools were also tested under similar cutting conditions. The predominant wear mechanisms of the various ceramic overcoats and cemented WC-Co were investigated using surface profilometry, scanning electron microscopy, and energy dispersive X-ray analysis. Representative results of the tool wear behavior are presented, and the significance of each ceramic layer on the overall tool wear resistance is interpreted in light of the identified dominant wear mechanisms. Delamination wear characterized by the propagation and linkage of surface, subsurface, and interfacial cracks, abrasion, surface plastic shearing, plucking of carbide grains, and dissolution/diffusion are shown to occur depending on the tool material. These wear processes are not mutually exclusive; they may occur simultaneously at different positions on the same tool surface. Based on nose wear data, correlations between wear lives of coated and uncoated tools and feedrate are established.
Subject
Surfaces, Coatings and Films,Surfaces and Interfaces,Mechanical Engineering,Mechanics of Materials
Reference21 articles.
1. Chubb J. P. , and BillinghamJ., 1980, “Coated Cutting Tools—A Study of Wear Mechanisms in High Speed Machining,” Wear, Vol. 61, pp. 283–293.
2. Chubb J. P. , BillinghamJ., HallD. D., and WallsJ. M., 1980, “Comparison of Wear Behaviour of Single- and Multilayer Coated Carbide Cutting Tools,” Metals Technology, Vol. 7, pp. 293–299.
3. Dearnley P. A. , and TrentE. M., 1982, “Wear Mechanisms of Coated Carbide Tools,” Metals Technology, Vol. 9, pp. 60–75.
4. Dearnley P. A. , 1985, “Rake and Flank Wear Mechanisms of Coated and Uncoated Cemented Carbides,” ASME JOURNAL OF ENGINEERING MATERIALS AND TECHNOLOGY, Vol. 107, pp. 68–82.
5. Heydari, F., Wallbank, J., and Pashby, I. R., 1987, “Evaluation of Wear Mechanisms and Tool Lives When Machining 0.3% Mn-Mo Steel With Coated Carbide and Ceramic Tools,” Wear of Materials, pp. 313–324.
Cited by
37 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献