Jet Impingement Boiling From a Circular Free-Surface Jet During Quenching: Part 1—Single-Phase Jet
Author:
Hall David E.1, Incropera Frank P.2, Viskanta Raymond3
Affiliation:
1. Michelin Americas Research Corporation, 515 Michelin Road, Greenville, SC 29602 2. Notre Dame University, South Bend, IN 46556 3. School of Mechanical Engineering, Purdue University, West Lafayette, IN 47907
Abstract
This paper reports results from an experimental study of boiling heat transfer during quenching of a cylindrical copper disk by a subcooled, circular, free-surface water jet. The disk was heated to approximately 650°C, and as quenching occurred, transient temperature measurements were taken at discrete locations near the surface and applied as boundary conditions in a conduction model to deduce transient heat flux distributions at the surface. Results are presented in the form of heat flux distributions and boiling curves for radial locations varying from the stagnation point to ten nozzle diameters for jet velocities between 2.0 and 4.0 m/s 11,300⩽Red⩽22,600. Data for nucleate boiling in the stagnation region and spatial distributions of maximum heat flux are presented and are in good agreement with correlations developed from steady-state experiments. Spatial distributions of minimum film boiling temperatures and heat fluxes are also reported and reveal a fundamental dependence on jet deflection and streamwise location. A companion paper (Hall et al., 2001) describes single-phase and boiling heat transfer measurements from a two-phase (water-air), free-surface, circular jet produced by injecting air bubbles into the jet upstream of the nozzle exit.
Publisher
ASME International
Subject
Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science
Reference31 articles.
1. Viskanta, R., and Incropera, F. P., 1992, “Quenching with Liquid Jet Impingement,” Heat and Mass Transfer in Materials Processing, Hemisphere, I. Tanasawa and N. Lior, eds., New York, pp. 455–476. 2. Wolf, D. H., Incropera, F. P., and Viskanta, R., 1993, “Jet Impingement Boiling,” Advances in Heat Transfer, J. P. Hartnett, T. F. Irvine, and Y. I. Cho, eds., Academic Press, Inc., Boston, 23, pp. 1–132. 3. Vader, D. T., Incropera, F. P., and Viskanta, R., 1992, “Convective Nucleate Boiling on a Heated Surface Cooled by an Impinging, Planar Jet of Water,” ASME J. Heat Transfer, 114, pp. 152–160. 4. Wolf, D. H., Incropera, F. P., and Viskanta, R., 1996, “Local Jet Impingement Boiling Heat Transfer,” Int. J. Heat Mass Transf., 39, pp. 1395–1406. 5. Kumagai, S., Suzuki, S., Sano, Y., and Kawazoe, M., 1995, “Transient Cooling on a Hot Metal Slab by an Impinging Jet with Boiling Heat Transfer,” L. S. Fletcher and T. Aiahara, eds., Proceedings, ASME/JSME Thermal Engineering Joint Conference, Vol. 2, ASME, New York, pp. 347–352.
Cited by
80 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献
|
|