Delamination in High Speed Drilling of Carbon Fiber Reinforced Plastic (CFRP)-Reference-Cited by-同舟云学术

Delamination in High Speed Drilling of Carbon Fiber Reinforced Plastic (CFRP)

Published:2008-08 Issue:15 Volume:42 Page:1523-1532
ISSN:0021-9983
Container-title:Journal of Composite Materials
language:en
Short-container-title:Journal of Composite Materials

Author:

Campos Rubio Juan C.¹,Abrão Alexandre M.²,Eustáquio Faria Paulo²,Correia Antônio Esteves³,Davim João Paulo⁴

Affiliation:

1. Department of Mechanical Engineering, Federal University of Minas Gerais, Av. Antônio Carlos, 6627 - Pampulha Belo Horizonte MG, CEP: 31.270-901, Brazil, ,

2. Department of Mechanical Engineering, Federal University of Minas Gerais, Av. Antônio Carlos, 6627 - Pampulha Belo Horizonte MG, CEP: 31.270-901, Brazil

3. Department of Mechanical Engineering and Industrial Management School of Technology, Polytechnic Institute of Viseu Campus de Repeses, 3504-510 Viseu, Portugal

4. Department of Mechanical Engineering, University of Aveiro Campus Santiago, 3810-193 Aveiro, Portugal

Abstract

When holes are produced on carbon fiber reinforced plastic (CFRP) laminates, in particular for the aerospace and automotive industries, special attention should be focused on as the machining parameters influencing the damage. In this study special drill bits and high-speed cutting (HSC) are used and compared with conventional cutting conditions. The digital image of the damage was conducted in order to analyze the delamination when two composite boards were drilled simultaneously. The experimental results indicated that the use of HSC in drilling is suitable to reduce the damages produced in CFRP with material removal rate increasing considerably.

Publisher

SAGE Publications

Subject

Materials Chemistry,Mechanical Engineering,Mechanics of Materials,Ceramics and Composites

Link

http://journals.sagepub.com/doi/pdf/10.1177/0021998308092205

Reference19 articles.

1. Drilling of fiber reinforced plastics: A review

2. A novel approach based on digital image analysis to evaluate the delamination factor after drilling composite laminates

3. Effects of hole machining defects on strength and fatigue life of composite laminates

Cited by 60 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Investigation of Drilling Holes in CFRP for Aircraft Using cBN Electroplated Ball End Mill Using Helical Interpolation Motion;International Journal of Automation Technology;2024-03-05

2. Sustainable shape formation of multifunctional carbon fiber-reinforced polymer composites: A study on recent advancements;Mechanics of Advanced Materials and Structures;2023-09-28

3. Comparative analysis of drilled and molded holes in short natural fiber reinforced composites;Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications;2023-07-30

4. A review on CFRP drilling: fundamental mechanisms, damage issues, and approaches toward high-quality drilling;Journal of Materials Research and Technology;2023-05

5. Infrared Thermographic Inspection of Aerospace CFRP Laminates and Sandwiches: Resistive Heating Element as a Source of Thermal Stimulation;2022 New Trends in Civil Aviation (NTCA);2022-10-26