Unambiguous Determination of 3D Fiber Orientation Distribution in Thermoplastic Composites Using SAM Image of Elliptical Mark and Interference Fringe-Reference-Cited by-同舟云学术

Unambiguous Determination of 3D Fiber Orientation Distribution in Thermoplastic Composites Using SAM Image of Elliptical Mark and Interference Fringe

Published:2005-02 Issue:4 Volume:39 Page:287-299
ISSN:0021-9983
Container-title:Journal of Composite Materials
language:en
Short-container-title:Journal of Composite Materials

Author:

Kawamura Munehiro¹,Ikeda Satoshi¹,Morita Satoru²,Sanomura Yukio³

Affiliation:

1. Yamaguchi Prefectural Industrial Technology Institute, 4-1-1 Asutopia, Ube, Yamaguchi 755-0190, Japan

2. Department of Computer Science and Systems Engineering, Yamaguchi University, 2-16-1 Tokiwadai, Ube, Yamaguchi 755-8611, Japan

3. Department of Mechanical Engineering, Tamagawa University, 6-1-1 Tamagawa-gakuen, Machida, Tokyo 194-8610, Japan,

Abstract

The in-plane angle determined using an optical reflection microscope with an image analyzer is ambiguous, because the same elliptical image would be obtained for a fiber. A method of determining the three-dimensional (3D) fiber orientation distribution using the scanning acoustic microscopy (SAM) image of an elliptical mark and interference fringe is proposed. The interference fringe appearing in the composite in the direction of a fiber is observed by SAM. One can easily determine the in-plane angle without ambiguity by adopting this information of interference fringes. It is shown that this technique is effective for the determination of the 3D fiber orientation distribution in plaque and cylindrical composite parts.

Publisher

SAGE Publications

Subject

Materials Chemistry,Mechanical Engineering,Mechanics of Materials,Ceramics and Composites

Link

http://journals.sagepub.com/doi/pdf/10.1177/0021998305046463

Reference25 articles.

1. Materials property modelling and design of short fibre composites

2. The Use of Tensors to Describe and Predict Fiber Orientation in Short Fiber Composites

3. Fibre orientation calculation in injection moulding of reinforced thermoplastics

4. Macroscopic modelling of the evolution of fibre orientation during flow

Cited by 8 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. A procedure for determination of the microstructural probabilistic characteristics from micrographs and their impact on subsequent results;PAMM;2023-03

2. Comparing non-destructive 3D X-ray computed tomography with destructive optical microscopy for microstructural characterization of fiber reinforced composites;Composites Science and Technology;2019-11

3. Uncertainty quantification of fiber orientation distribution measurements for long-fiber-reinforced thermoplastic composites;Journal of Composite Materials;2017-09-28

4. 3D RVE Models Able to Capture and Quantify the Dispersion, Agglomeration, and Orientation State of CNT in CNT/PP Nanocomposites;Frontiers in Materials;2016-02-02

5. Unambiguous orientation in short fiber composites over small sampling area in a center-gated disk;Composites Part A: Applied Science and Manufacturing;2012-01