Study on Some Aspects of Machinability in Unreinforced and Reinforced Polyamides-Reference-Cited by-同舟云学术

Study on Some Aspects of Machinability in Unreinforced and Reinforced Polyamides

Published:2009-03-04 Issue:7 Volume:43 Page:725-739
ISSN:0021-9983
Container-title:Journal of Composite Materials
language:en
Short-container-title:Journal of Composite Materials

Author:

Gaitonde V.N.¹,Karnik S.R.²,Mata Francisco³,Davim J. Paulo⁴

Affiliation:

1. Department of Industrial and Production Engineering, B. V. B. College of Engineering and Technology, Hubli 580 031, Karnataka, India,

2. Department of Electrical and Electronics Engineering, B. V. B. College of Engineering and Technology, Hubli 580 031, Karnataka, India

3. Polytechnic School of Almadén, University of Castilla-La Mancha, Plaza Manuel Meca, 1, 13412 Almaden, Spain

4. Department of Mechanical Engineering, University of Aveiro, Campus Santiago 3810-193 Aveiro, Portugal

Abstract

The polyamides have replaced many traditional metallic materials due to excellent property profile. Even though polyamides are produced as near net shapes, machining has to be performed in the final stage of production. In this article an attempt was been made to study the effects of cutting speed and feed rate on machining force, cutting power, and specific cutting pressure during turning of PA6 and PA66 GF30 polyamides with K10 carbide tool. The response surface methodology (RSM) based parametric analysis reveals that machining force and cutting power increase with cutting conditions, while specific cutting pressure decreases with increase in feed rate.

Publisher

SAGE Publications

Subject

Materials Chemistry,Mechanical Engineering,Mechanics of Materials,Ceramics and Composites

Link

http://journals.sagepub.com/doi/pdf/10.1177/0021998309101298

Reference15 articles.

1. Tribological studies of polyamide 6 and high-density polyethylene blends filled with PTFE and copper oxide and reinforced with short glass fibers

2. A comparative evaluation of the turning of reinforced and unreinforced polyamide

3. Comparison of nanocomposites based on nylon 6 and nylon 66

4. The effect of different metallic counterface materials and different surface treatments on the wear and friction of polyamide 66 and its composite in rolling–sliding contact

Cited by 22 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Investigation on machining of GFRP through ANOVA, DFA, and CoCoSo method combined with Taguchi approach;Journal of Reinforced Plastics and Composites;2024-03-22

2. Modeling and optimization in turning of PA66-GF30% and PA66 using multi-criteria decision-making (PSI, MABAC, and MAIRCA) methods: a comparative study;The International Journal of Advanced Manufacturing Technology;2022-12-13

3. A comprehensive review on polymer matrix composites: material selection, fabrication, and application;Polymer Bulletin;2022-01-23

4. Experimental investigation on the machinability characteristics in drilling of syntactic foams;IOP Conference Series: Materials Science and Engineering;2021-10-01

5. Investigation of cutting and specific cutting energy in turning of POM-C using a PCD tool: Analysis and some optimization aspects;Journal of Cleaner Production;2021-06