Adhesive behaviour of carbon fibre reinforced plastic panels manufactured using woven and unidirectional tape after ultraviolet laser surface treatment-Reference-Cited by-同舟云学术

Adhesive behaviour of carbon fibre reinforced plastic panels manufactured using woven and unidirectional tape after ultraviolet laser surface treatment

Published:2017-07-04 Issue:7 Volume:52 Page:853-865
ISSN:0021-9983
Container-title:Journal of Composite Materials
language:en
Short-container-title:Journal of Composite Materials

Author:

Botana-Galvín Marta¹,Blanco Ginesa¹,González-Rovira Leandro¹,Rodríguez Miguel A²,Botana Francisco J¹

Affiliation:

1. Materials Science, Metallurgical Engineering and Inorganic Chemistry Department, School of Engineering, Universidad de Cádiz, Spain

2. Titania, Ensayos y Proyectos Industriales, El Puerto de Santa María, Spain

Abstract

This paper describes the results obtained when ultraviolet laser treatment was performed as a surface treatment prior to adhesive bonding for two aeronautical carbon fibre-reinforced plastics based on an epoxy resin prepreg. Different laser-processing parameters were employed, and their effect on the surfaces was analysed through morphological characterisation and wettability studies. X-ray photoelectron spectroscopy measurements were performed to determine the cleaning and activation effects of the treatment. The strength of the bonded joint was studied for laser-treated and manually ground samples. Samples processed under the selected laser conditions exhibited better adhesive behaviour than the manually treated samples, thereby suggesting that ultraviolet laser treatment could be used as an alternative method for surface activation of aeronautical composites based on epoxy resins.

Publisher

SAGE Publications

Subject

Materials Chemistry,Mechanical Engineering,Mechanics of Materials,Ceramics and Composites

Link

http://journals.sagepub.com/doi/pdf/10.1177/0021998317718614

Reference28 articles.

1. Bonding of CFRP primary aerospace structures – discussion of the certification boundary conditions and related technology fields addressing the needs for development

2. The Use of Peel Ply as a Method to Create Reproduceable But Contaminated Surfaces for Structural Adhesive Bonding of Carbon Fiber Reinforced Plastics

3. Influence of fibre reinforcement and peel ply surface treatment towards adhesion of composite surfaces

4. Surface pretreatment of carbon fibre-reinforced composites for adhesive bonding

Cited by 16 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Predictive models based on RSM and ANN for roughness and wettability achieved by laser texturing of S275 carbon steel alloy;Optics & Laser Technology;2024-01

2. Review of the surface treatment process for the adhesive matrix of composite materials;International Journal of Adhesion and Adhesives;2023-08

3. Effects of nanosecond laser ablation parameters on surface modification of carbon fiber reinforced polymer composites;Journal of Composite Materials;2023-05-30

4. Study of Abrasive Water Jet Machining as a Texturing Operation for Thin Aluminium Alloy UNS A92024;Materials;2023-05-19

5. Experimental Investigation on Ablation Behaviors of CFRP Laminates in an Atmospheric Environment Irradiated by Continuous Wave Laser;Polymers;2022-11-23