Flow Analysis during On-line and Radial Injection Applications in Permeability Measurements-Reference-Cited by-同舟云学术

Flow Analysis during On-line and Radial Injection Applications in Permeability Measurements

Published:2005-08-16 Issue:18 Volume:24 Page:1909-1920
ISSN:0731-6844
Container-title:Journal of Reinforced Plastics and Composites
language:en
Short-container-title:Journal of Reinforced Plastics and Composites

Author:

Hattabi M.¹,Echaabi J.²,Bensalah M. O.³,Bréeard J.,Saouab A.⁴

Affiliation:

1. Plastics and Composites Laboratory, ENSEM, BP 8118, Oasis, Casablanca, Morocco

2. Plastics and Composites Laboratory, ENSEM, BP 8118, Oasis, Casablanca, Morocco;

3. Mechanical and Materials Laboratory, Avenue Inb Batouta BP 1014, Faculté des Sciences, Rabat, Morocco

4. Physics, Mechanics and Geosciences Laboratory of the Havre, Universite of the Havre, 25, rue Philippe Lebon, BP 540, 76058 Le Havre Cedex, France

Abstract

In this study, a simple technique for revealing the key parameters (permeability, frontend kinetics) of the RTM process is developed. The variations in permeability during the technique lift the capillary effect, which is modeled for two configurations. The analysis of the front-end kinetics helps to identify the permeability tensor. The examination of the capillary number gives evidence of a non-saturated zone, characterized by a critical length.

Publisher

SAGE Publications

Subject

Materials Chemistry,Polymers and Plastics,Mechanical Engineering,Mechanics of Materials,Ceramics and Composites

Link

http://journals.sagepub.com/doi/pdf/10.1177/0731684405054356

Reference24 articles.

1. A finite element/control volume approach to mold filling in anisotropic porous media

2. Numerical Analysis of the Resin Flow in Resin Transfer Molding

3. Isothermal flow simulation of liquid composite molding

4. Numerical simulation of three-dimensional mold filling process in resin transfer molding using quasi-steady state and partial saturation formulations