Deformation analysis of short glass fiber-reinforced polypropylene injection-molded plastic parts-Reference-Cited by-同舟云学术

Deformation analysis of short glass fiber-reinforced polypropylene injection-molded plastic parts

Published:2011-08 Issue:16 Volume:30 Page:1367-1372
ISSN:0731-6844
Container-title:Journal of Reinforced Plastics and Composites
language:en
Short-container-title:Journal of Reinforced Plastics and Composites

Author:

Sikló B.¹,Cameron K.²,Kovács J.G.¹

Affiliation:

1. Department of Polymer Engineering, Budapest University of Technology and Economics, H-1111 Budapest, Hungary.

2. University of the West of Scotland, Almada Street, Scotland.

Abstract

The warpage of injection-molded plastic parts is a complex problem being affected by different technological parameters, material properties, and mold design. Hence, the description of the deformation is difficult as well. This article presents the effect of fiber content and mold temperature difference on the deformation of polypropylene parts. Based on the measurement results, a linear approximation and a calculation method are shown, which can be used to jointly determine the ideal fiber content and mold temperature difference to produce undeformed plastic parts.

Publisher

SAGE Publications

Subject

Materials Chemistry,Polymers and Plastics,Mechanical Engineering,Mechanics of Materials,Ceramics and Composites

Link

http://journals.sagepub.com/doi/pdf/10.1177/0731684411426203

Reference26 articles.

1. Examination of injection moulded thermoplastic maize starch

2. Modeling and investigation of the reinforcing effect of maize hull in PE matrix composites

3. The effect of EVA content on the processing parameters and the mechanical properties of LDPE/ground tire rubber blends

4. Effect of temperature on tensile properties of injection moulded short glass fibre and glass bead filled ABS hybrids

5. Effect of mold temperature on short and long-term mechanical properties of PBT

Cited by 11 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Experimental investigation on mechanical properties, shrinkage and warpage of injection molded short glass fiber reinforced polypropylene;Journal of Composite Materials;2023-06-19

2. ÇOK ÖLÇEKLİ MALZEME MODELLEMESİ İLE KISA ELYAF TAKVİYELİ KOMPOZİTLERİN YAPISAL ANALİZİ: ARAÇ PEDALI ÖRNEĞİ;Uludağ University Journal of The Faculty of Engineering;2023-04-25

3. Experimental Investigation and Applicability of Multi-Stage Simulations in the Case of a Thick-Walled Injection-Moulded Composite;Applied Sciences;2022-08-23

4. Modelling of Process-Induced Deformation for Composite Parts Considering Tool-Part Interaction;Materials;2020-10-11

5. Warpage Reduction of Glass Fiber Reinforced Plastic Using Microcellular Foaming Process Applied Injection Molding;Polymers;2019-02-19