Formability and densification behavior of two-layered structure powder metallurgical hot-pressed Al-Cu/Al composites during hot-upsetting

Abstract

An experimental investigation has been performed on the hot formability and densification characteristics of Al-Cu/Al two-layered structure composites. The two-layered composites having different Cu compositions in the Al-Cu layer such as (Cu: 5wt. %, 10wt. %, and 15wt. %) were prepared using the powder metallurgy (P/M) route. The composites were hot-pressed as layer by layer in a steel cylindrical die at 550°C temperature with 0.9 initial relative density (IRD) and 0.1 s−1 strain rate. The preforms were hot deformed between two flat dies with a capacity of 50-ton hydraulic press machine at a temperature range of 150°C – 450°C under triaxial stress state condition. The hot-upsetting behaviour of preforms was analyzed until the cracks begin on the cylindrical preform at the outer surface. The effect of different Cu composition and various deformation temperatures on two-layered preforms were discussed. Results revealed that the (10wt. %Cu) preform achieved good cooperative deformation behaviour between Al-Cu and Al layers at the interface region. The relationship between the process parameters was discussed such as the effect of axial stress ([Formula: see text]), relative density ( R) on axial strain ([Formula: see text]) and formability stress index ( β), different stress ratio parameters ([Formula: see text], [Formula: see text]) on relative density ( R).