Geometric design, meshing simulation, and stress analysis of pure rolling cylindrical helical gear drives

Abstract

The geometric design, meshing performance, and mechanical behavior of pure rolling helical gear drives are presented. Parametric equations for contact curves on the pinion and gear are determined by coordinate transformation of the active designed pure rolling meshing line for the whole cycle of meshing. Moreover, parametric equations for the tooth surfaces of helical gears with convex-to-convex meshing type are derived according to the motion of generatrices in the transverse section along the calculated contact curves. Then, the basic design parameters are analyzed and formulas for calculation of the geometric size are given. The meshing performance and mechanical behavior, including contact patterns, loaded function of transmission errors, and variation of stresses for two pitch angles of meshing are compared with those of a reference design of micro-geometry modified involute helical gears. Besides, the influence of basic design parameters on tooth contact analysis and stress analysis is studied. The analysis of the results shows that the proposed pure rolling helical gears have the advantage of reducing the relative sliding between tooth surfaces and the possibility of designing pure rolling helical gears with a small number of teeth, though the contact strength of the surfaces is impaired. However, if the appropriate design parameters and Hermite curve parameters for the fillets are properly evaluated as proposed here, the mechanical behavior of the proposed pure rolling helical gear drive, in terms of contact patterns and variation of bending stresses can be superior to that of the micro-geometry modified involute helical gear drives.