Affiliation:
1. Department of Mechanical Engineering, Okayama University, Tsushima-Naka, Okayama, Japan
Abstract
This paper is concerned with engine experiments and spectroscopic analysis of premixed mixture ignition in the end-gas region (PREMIER) combustion in a pilot fuel ignited, natural gas dual-fuel engine. The results reveal the characteristics and operating parameters that induce and affect this combustion mode. The PREMIER combustion is followed by natural gas flame propagation. Pilot-injected diesel fuel ignites the natural gas/air mixture, and the flame propagates before the natural gas/air mixture is autoignited in the end-gas region. This combustion cycle differs from a knocking cycle in terms of combustion and emission characteristics. The PREMIER combustion can be controlled by pilot fuel injection timing, the equivalence ratio, and the exhaust gas recirculation (EGR) rate, and can be used as an effective method for high load extension on a dual-fuel engine. An analysis of the relationship between the maximum in-cylinder pressure and its crank angle (CA) is used to compare combustion dynamics during conventional, PREMIER, and knocking combustion. In PREMIER combustion, the heat release gradually transforms from the slower first-stage flame rate to the faster second-stage rate. During PREMIER combustion, the maximum indicated mean effective pressure (IMEP) and thermal efficiency increase by about 25 per cent compared with those of conventional combustion, and low carbon monoxide (CO) and total hydrocarbon (HC) emissions can be achieved. However, nitrogen oxide (NO x) emissions increase. Spectroscopic analysis shows that the intensity of the OH* emissions in the end-gas region increases as the combustion mode transforms from conventional to PREMIER to knocking. In all three modes, emission fluctuations above 650 nm can be observed in the end-gas region. These emissions are attributed to the luminosity from soot particles formed during the concurrent diesel fuel combustion.
Subject
Mechanical Engineering,Ocean Engineering,Aerospace Engineering,Automotive Engineering
Cited by
68 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献