Affiliation:
1. Marine Maintenance Department, Faculty of Marine Engineering, Gdynia Maritime University, Gdynia, POLAND
Abstract
The article presents the research results referring to the analysis of the influence of cuttingparameters on value of cutting forces during turning pins of shaft. For the monitoring of forces during lathingprocess used Kistler dynamometer. The dynamometer is used for dynamic and quasistatic measurements of the3 orthogonal components of any forces acting on the cover plate (Fx - radial force, Fy - feed force andFz - cutting force). The turning process was carried out on a universal CU500MRD/1000 centre lathe. Theresearch was performed on a shaft made of 7020 aluminium alloy. Chemical composition of aluminium alloywas measured by Solaris-ccd plus optical spectrometer. The finishing turning process was carried out by cuttingtool with CCGT09T302-DL removable insert by Duracarb. During turning the following machining parameterswere used: cutting speed, feed and depth of cut. The goal of the paper was to define the influence of treatmentconditions on values of forces during turning process, and thus monitoring the wear of the cutting insert.
Publisher
World Scientific and Engineering Academy and Society (WSEAS)
Subject
Artificial Intelligence,General Mathematics,Control and Systems Engineering
Reference23 articles.
1. R. A. Mali, M. D. Agrahari, T. V.K. Gupta, FE Based Simulation and Experimental Validation of Forces in Dry Turning of Aluminium 7075, Materials Today: Proceedings, 2019, In Press, Corrected Proof.
2. W. Labuda, The Influence of Treatments Conditions on Cutting Forces and Temperature during Finish Turning of Stainless S teel by CCET09T302R-MF. In Proceedings of 27th Anniversary International Conference on Metallurgy and Materials. Ostrava, Czech Republic, 2018, pp. 1163 – 1168.
3. D. K. Rao, K. Srinivas, An Analysis of Feature Identification for Tool Wear Monitoring by Using Acoustic Emission. Traitement du Signal, Vol. 34, No. 3-4, 2017, pp. 117-135.
4. M. S. H. Bhuiyan, I. A. Choudhury, M. Dahari, Monitoring the Tool Wear, Surface Roughness and Chip Formation Occurrences using Multiple Sensors in Turning, Journal of Manufacturing Systems, Vol. 33, No. 4, 2014, pp. 476-487.
5. D. I. Lalwani, N. K. Mehta, P. K. Jain, Experimental Investigations of Cutting Parameters Influence on Cutting Forces and Surface Roughness in Finish Hard Turning of MDN 250 Steel. Journal of Materials Processing Technology, Vol. 206, No. 1–3, 2008, pp. 167-179.
Cited by
1 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献