Constructing the resistivity-to-sediment-type transform for the interpretation of airborne electromagnetic data

Abstract

A novel Markov chain Monte Carlo (MCMC)-based methodology was developed for the transformation of resistivity, derived from airborne electromagnetic (AEM) data, into sediment type. This methodology was developed and tested using AEM data and well sediment type and resistivity logs from Butte and Glenn Counties in the California Central Valley. Our methodology accounts for the spatially varying sensitivity of the AEM method by constructing different transforms separated based on the sensitivity of the AEM method. The large spatial separation that typically exists between the AEM data and the wells with sediment type logs was avoided by planning the acquisition of AEM data so as to fly as close as possible to the well locations. We had 55 locations with sediment type logs and AEM data separated by 100 m, determined to be the maximum acceptable separation distance. Differences in vertical resolution between the AEM method and the sediment type logs were addressed by modeling the physics of the AEM measurement, allowing for a comparison of field and AEM data generated during the MCMC process. The influence of saturation state was captured by creating one set of transforms for the region above the top of the saturated zone and another for below. Using the set of transforms developed at the 55 locations, an inverse distance weighting scheme that included a well quality ranking was used to construct a set of 12 (six sensitivity bins, and two saturation states) resistivity-to-sediment-type transforms at every AEM data location. These represent a set of transforms that accommodate the variation in AEM sensitivity and are independent of the inversion used to retrieve the resistivity model. Thus, these transforms avoid two of the significant limitations common to resistivity-to-sediment-type transforms used to interpret AEM data.