Affiliation:
1. St. Petersburg State University of Information Technologies, Mechanics and Optics
Abstract
Main technological approaches to production of lightconducting systems with scattering microstructures are considered with a special attention to processing method of the optical material influence on geometrical parameters of the being formed microstructure. Relevance of it is caused by an insufficiency of studying influence of the microstructural scattering element configuration distortion on output luminance distribution of the lightconducting systems (because of the technological features of their production). As exemplified by a lightconducting system made by milling technology, a physically correct simulation of this system is carried out, and influence of the microstructure relief on output luminance distribution is shown. For the simulation, the Lumicept program system was used, which has provided physical correctness of the modelling results.
Publisher
Redakcia Zhurnala Svetotekhnika LLC
Reference27 articles.
1. Shponkina Yu. Energy saving in electrical energy industry // ER, 2014, #3 (57), pp. 22–24.
2. ChangYi Li, JuiWen Pan “Highefficiency backlight module with two guiding modes” // Applied Optics, 2014, Vol. 53, # 8, pp. 1503–1511.
3. Young Chul Kim, TaeSik Oh, Yong Min Lee “Optimized pattern design of lightguide plate (LGP)” // Optica Applicata, 2011, Vol. XLI, No. 4, pp. 863–872.
4. Zhdanov D.D., Zhdanov A.D., Potyomin I.S. A quick method of constructing local equidistant distributions of micro geometrical objects of illumination systems // Optics and spectroscopy, 2015. #2, pp. 329–336.
5. ChaoHeng Chien, ZhiPeng Chen “Design and fabrication of the concentric circle light guiding plate for LEDbacklight module by MEMS technique” // Microsyst. Technol, 2007, #13, pp. 1529–1535, DOI 10.1007/s00542–006–0365y.