3D Printing Technology for Rapid Manufacturing Discone Antenna Based on PLA Material-Reference-Cited by-同舟云学术

3D Printing Technology for Rapid Manufacturing Discone Antenna Based on PLA Material

Published:2022-12-04 Issue: Volume: Page:
ISSN:
Container-title:2022 14th International Conference on Computational Intelligence and Communication Networks (CICN)
language:
Short-container-title:

Author:

Munir Achmad¹,Zulfi ²,Asthan Rheyuniarto Sahlendar³,Oktafiani Folin⁴

Affiliation:

1. Radio Telecommunication and Microwave Laboratory School of Electrical Engineering and Informatics Institut Teknologi Bandung,Bandung,Indonesia

2. Radio Telecommunication and Microwave Laboratory School of Electrical Engineering and Informatics, ITB School of Electrical Engineering, Telkom University,Bandung,Indonesia

3. School of Electrical Engineering and Informatics, ITB, ITERA,Radio Telecommunication and Microwave Laboratory,Department of Electrical Engineering, ITERA,Bandung,Indonesia

4. Radio Telecommunication and Microwave Laboratory School of Electrical Engineering and Informatics, ITB Research Center for Telecommunication, BRIN,Bandung,Indonesia

Publisher

IEEE

Link

http://xplorestaging.ieee.org/ielx7/10008224/10008233/10008352.pdf?arnumber=10008352

Reference16 articles.

1. Radiation Characteristics of Wideband Skeletal Discone Antenna

2. 3D-Printed Low-Pass Filter with Conical Inductors for Broadband RF Applications

3. 3-D Printed Dual-Band Filter Based on Spherical Dual-Mode Cavity

4. Wideband Dual-Polarized 3D Printed Quad-Ridged Horn Antenna

5. Design and Characterization of PLA-based Wideband 3D-Printed Discone Antenna

Cited by 5 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Characterization of A 3D-Printed PLA-Based Slotted SIW Antenna;2023 Workshop on Microwave Theory and Technology in Wireless Communications (MTTW);2023-10-04

2. Utilization of 3D Printing Technique for Manufacturing A Planar Marchand Balun Fed UHF Wideband Vivaldi Antenna;2023 Workshop on Microwave Theory and Technology in Wireless Communications (MTTW);2023-10-04

3. Design and Realization of A Wideband Quadratic Wire-shaped Discone Antenna;2023 Workshop on Microwave Theory and Technology in Wireless Communications (MTTW);2023-10-04

4. Utilization of 3D Printing Technique for Manufacturing A Planar Marchand Balun Fed UHF Wideband Vivaldi Antenna;2023 IEEE 13th International Conference on RFID Technology and Applications (RFID-TA);2023-09-04

5. Evaluation of Polylactic Acid Polymer as a Substrate in Rectenna for Ambient Radiofrequency Energy Harvesting;Journal of Low Power Electronics and Applications;2023-05-12