A Novel Method for Detecting the Onset and Location of Mechanical Failure by Correlating Engineering Stress With Changes in Magnetic Properties of UNS S32205 Duplex Stainless Steel Using Quantum Well Hall Effect Sensors-Reference-Cited by-同舟云学术

A Novel Method for Detecting the Onset and Location of Mechanical Failure by Correlating Engineering Stress With Changes in Magnetic Properties of UNS S32205 Duplex Stainless Steel Using Quantum Well Hall Effect Sensors

Published:2023 Issue: Volume:11 Page:78613-78622
ISSN:2169-3536
Container-title:IEEE Access
language:
Short-container-title:IEEE Access

Author:

Biruu Firew Abera¹^ORCID,Reccagni Pierfranco²,Engelberg Dirk²,Missous Mohamed³^ORCID

Affiliation:

1. Ethronics, Institute of Robotics and Autonomous Systems (IRAS), Adama, Ethiopia

2. Department of Materials, Metallurgy and Corrosion, School of Natural Sciences, The University of Manchester, Manchester, U.K

3. Department of Electrical and Electronic Engineering, School of Engineering, The University of Manchester, Manchester, U.K

Funder

U.K.’s Engineering and Physical Sciences Research Council

the “U.K. Research Centre in Non-Destructive Evaluation (RCNDE3)”

the “Future compound semiconductor manufacturing HUB.”

Publisher

Institute of Electrical and Electronics Engineers (IEEE)

Subject

General Engineering,General Materials Science,General Computer Science,Electrical and Electronic Engineering

Link

http://xplorestaging.ieee.org/ielx7/6287639/10005208/10194320.pdf?arnumber=10194320

Reference20 articles.

1. High sensitivity two-dimensional electron gas (2DEG) Quantum Well Hall Effect sensors for novel pre-failure engineering stress analysis and non-destructive testing systems;biruu,2020

2. 2D magnetic field sensing around defects in ferromagnetic and non-ferromagnetic materials using 2DEG Quantum Well Hall Effect sensor arrays;biruu;Proc 56th Annu Conf Brit Inst Non-Destructive Test (NDT),2017

3. Methodology of testing the magnetoelastic characteristic of ring-shaped cores under uniform compressive and tensile stresses;salach;J Electr Eng,2010

4. An Analytical Model for Prediction of Magnetic Flux Leakage from Surface Defects in Ferromagnetic Tubes