Affiliation:
1. Department of Mechanical Engineering, Indian Institute of Information Technology, Design and Manufacturing, Kancheepuram, Chennai 600127, Tamilnadu, India
Abstract
Drilling through bone is one of the common cutting processes involved in many of the orthopedic surgeries. In bone drilling, spindle speed, feed rate, diameter of the drill bit, drill bit geometry and method of cooling are the important parameters to influence the in-situ temperature, drill thrust force and quality characteristics of the drilled hole. Because of the selection of inappropriate drilling parameters, uncontrolled large drilling forces, continuous increase in temperature and mechanical damage to the local host bone were observed. As these adverse effects lead to poor bone–implant contact and often a revision surgery, performing a surgical drilling with optimal parameters is essential to succeed in the surgical procedure. It was observed that in addition to the variations in apparent bone density, the orientation of osteons influences the drilling thrust force and temperature in bone drilling. Ten adult cadaveric human femurs from the age group of 32–65 years were considered and drilling experiments were conducted on proximal-diaphysis, mid-diaphysis and distal-diaphysis regions in the longitudinal, radial and circumferential directions. Bone drilling with different spindle speeds (500, 1000 and 1500[Formula: see text]rpm), feed rates (40, 60 and 80[Formula: see text]mm/min), and apparent density in the range of 0.98[Formula: see text]g/cm3 to 1.98[Formula: see text]g/cm3 was investigated in this work using a 3.20[Formula: see text]mm diameter surgical drill-bit. The generation of in-situ temperature as well as thrust force at each target location was measured using [Formula: see text]-type thermocouple and Kistler[Formula: see text] dynamometer, respectively. Taguchi method based on membership function was used to optimize the drilling process. Then the efficacy of the method in reducing the in-situ temperature and thrust force, and quality of the drilled hole in respect of anatomical region and drilling direction was investigated using pull-out strength of the bone screws. Results revealed that the optimal parameters obtained from the Taguchi method based on membership function could simultaneously minimize the temperature as well as thrust force in bone drilling. The proposed method can be adopted to minimize the temperature and thrust force, and choose the best location nearest to the defect site for strong implant fixation by using CT datasets of the patient as the only input.
Funder
Science and Engineering Research Board, New Delhi, India
Publisher
World Scientific Pub Co Pte Lt
Cited by
3 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献