Preparation of Thin Polycarbonate Film and Its Application to PIXE Analysis of Anionic Elements in Water Samples

Abstract

A polycarbonate film of thin and uniform thickness was prepared. A casting solution for film-formation was made up by diluting a solution of poly (bisphenol A carbonate) in chloroform by a factor of two to three with benzene. A uniform film was created by dropping 0.2-0.3 cm3 of the casting solution slowly on a water surface within an aperture (20 mm diameter) of Mylar target frame floating on 50 wt% sucrose aqueous solution. Films of 0.14-0.27 mg/cm2 thickness thus prepared offer a good combination of mechanical strength and low continuum backgrounds. To test PIXE analysis of anionic species in water, targets containing SO 42-, Cr 2 O 72-, AsO 43-, and Ga 3+-internal standard were prepared by depositing 100 μl of the test solutions onto the polycarbonate film, and irradiated in vacuum by 3 MeV proton beams. The difference between the nominal and the analyzed concentrations seldom exceeded ± 15 % in the range from 10 to 2000 ppb.