Towards a geodetic earthquake catalogue for Central America: detecting coseismic deformation in Costa Rica using Sentinel-1 InSAR

Abstract

SUMMARY Earthquake source parameters can be estimated using seismological observations, but the identification of the fault responsible is often complicated by location uncertainties and the inherent ambiguity between nodal planes. Satellite Interferometric Synthetic Aperture Radar (InSAR) can be used to observe ground deformation and model fault geometry but is limited by climate conditions (water vapour) and ground coverage (dense vegetation). In the tropics, the atmosphere is dynamic and most regions are densely vegetated, making detecting coseismic deformation challenging. Here, we perform a systematic inspection of coseismic interferograms from Sentinel-1 SAR images, to assess their suitability for detecting coseismic deformation in Costa Rica. Using data from the seismological network, we target seven earthquakes between 2016 and 2020 with depths $\le \, 20$ km and magnitudes Mw 5.3–6.2. For each event, we use the seismic parameters to compute line-of-sight displacements for ascending and descending geometries and for both nodal planes and generate 12- and 24-d coseismic interferograms where available. We obtain interferograms with coseismic displacement signals for three of the seven earthquakes. We invert the geodetic data to retrieve the earthquake source parameters but the lack of offshore geodetic coverage causes trade-offs between parameters and large uncertainties. The Jacó and Golfito earthquakes likely occurred on the subduction interface and the geodetic locations were 6–9 km closer to the coast than previous seismic estimates. The Burica earthquake occurred on a shallow steeply dipping thrust fault in the outer forearc. For the other earthquakes, no coseismic deformation was detected due to atmospheric noise or poor coherence. These results demonstrate the suitability of 12-d Sentinel-1 interferograms for monitoring shallow earthquakes of magnitude > Mw 5.7 in Central America. This approach can be used to begin a surface deformation catalogue for the region, which will ultimately help improve the understanding of active deformation processes and improve hazard maps.