PrimerPooler: automated primer pooling to prepare library for targeted sequencing

Abstract

Abstract Targeted next-generation sequencing based on PCR amplification involves pooling of hundreds to thousands of primers, for preamplification and subsequent parallel single/multiplex PCR. It is often necessary to allocate the set of primers into subpools, a common issue being potential cross-hybridization. For smaller numbers of primers, pool division can be done manually using trial and error to minimize potential hybridization, but this becomes inefficient and time consuming with increasing numbers of primer pairs. We developed PrimerPooler that automates swapping of primer pairs between any user-defined number of subpools to obtain combinations with low-potential interactions. PrimerPooler performs inter-/intra-primer hybridization analysis to identify the adverse interactions, as well as simultaneous mapping of all primers onto a genome sequence in a single run without requiring a prior index of the genome. This allows detection of overlapping primer pairs and allocation of these primer pairs into separate subpools where tiling approaches are used. Using PrimerPooler, 1153 primer pairs were assigned to three preamplification pools (388, 389 and 376 primer pairs each), then 144 subpools of six- to nine-plex PCR for Fluidigm Access Array PCR, followed by Illumina MiSeq sequencing. With optimized experimental protocols, an average of 3269 reads was achieved for the targeted regions, with 95% of targets covered by at least 50 reads, the minimal depth of reads for confident variant calling. PrimerPooler provides a fast and highly efficient stratification of primer pairs for targeted enrichment, thus ensuring representative amplification of the targeted sequences. PrimerPooler is also able to analyse degenerate primers, and is thus also useful for microbiological identification and related target sequencing.