Deriving polarization properties of desert-reflected solar spectra with PARASOL data
Author:
Sun W., Baize R. R., Lukashin C., Hu Y.ORCID
Abstract
Abstract. Highlights: 1. Spectral polarization state of reflected solar radiation is needed in correcting satellite data. 2. An algorithm for deriving spectral polarization state of solar light from desert is reported. 3. PARASOL data at 3 polarized channels are used in deriving polarization of whole spectra. 4. Desert-reflected solar ligh's polarization state at any wavelength can be obtained. One of the major objectives of the Climate Absolute Radiance and Refractivity Observatory (CLARREO) is to conduct highly accurate spectral observations to provide an on-orbit inter-calibration standard for relevant Earth observing sensors with various channels. To calibrate an Earth observing sensor's measurements with the highly accurate data from the CLARREO, errors in the measurements caused by the sensor's sensitivity to the polarization state of light must be corrected. For correction of the measurement errors due to the light's polarization, both the instrument's dependence to incidence's polarization status and the on-orbit knowledge of polarization state of light as function of observed scene type, viewing geometry, and solar wavelength, are required. In this study, an algorithm for deriving spectral polarization state of solar light from desert is reported. The desert/bare land surface is assumed to be composed of two types of areas: fine sand grains with diffuse reflection (Lambertian non-polarizer) and quartz-rich sand particles with facets of various orientations (specular-reflection polarizer). The adding-doubling radiative transfer model (ADRTM) is applied to integrate the atmospheric absorption and scattering in the system. Empirical models are adopted in obtaining the diffuse spectral reflectance of sands and the optical depth of the dust aerosols over the desert. The ratio of non-polarizer area to polarizer area and the angular distribution of the facet orientations are determined by fitting the modeled polarization states of light to the measurements at 3 polarized channels (490, 670, and 865 nm) by the Polarization and Anisotropy of Reflectances for Atmospheric Science instrument coupled with Observations from a Lidar (PARASOL). Based on this physical model of surface, desert-reflected solar light's polarization state at any wavelength in the whole solar spectra can be calculated with the ADRTM.
Funder
Langley Research Center
Publisher
Copernicus GmbH
Reference42 articles.
1. Aoki, T., Mikami, M., and Liu, W.: Spectral albedos of desert surfaces and size distributions of soil particles measured around Qira and Aksu in the Taklimakan Desert, J. Arid Land Studies, 11, 259–266, 2002. 2. Bowker, D., Davis, R., Myrick, D., Stacy, K., and Jones, W.: Spectral Reflectances of Natural Targets For Use in Remote Sensing Studies, NASA RP-1139, NASA Langley Research Center, Hampton, Virginia, USA, 1985. 3. Bréon, F.-M., Tanré, D., Lecomte, P., and Herman, M.: Polarized reflectance of bare soils and vegetation: measurements and models, IEEE T. Geosci. Remote, 33, 487–499, 1995. 4. Clough, S. A. and Iacono, M. J.: Line-by-line calculations of atmospheric fluxes and cooling rates II: application to carbon dioxide, ozone, methane, nitrous oxide, and the halocarbons, J. Geophys. Res., 100, 16519–16535, 1995. 5. Clough, S. A., Iacono, M. J., and Moncet, J.-L.: Line-by-line calculation of atmospheric fluxes and cooling rates: application to water vapor, J. Geophys. Res., 97, 15761–15785, 1992.
|
|