Author:
Arhat Roman,Shchetynin Viktor,Puzyr Ruslan,Savelov Dmitry,Haikova Tetiana
Abstract
The development of a method for drawing cylindrical parts without pressing the workpiece flange, which allows reducing the cost of production due to the use of dies without a fit ring and single-acting presses. The performed research revealed that this method results in obtaining cylindrical parts with drawing ratios typical for pressing drawing. In this case, the different thickness of the finished product is several times less compared with the same type of semi-finished products obtained by drawing with a fit ring. Steel, aluminum and copper workpieces were researched. The best results were shown by more plastic materials. This method is not applicable for materials with the less than 0.25 mm thickness.
Reference38 articles.
1. Haikova T., Puzyr R., Dragobetsky V., Symonova A., Vakylenko R., Finite-Element Model of Bimetal Billet Strain Obtaining Box-Shaped Parts by Means of Drawing. In: Ivanov V. et al. (eds) Advances in Design, Simulation and Manufacturing II, Proceedings of the 2nd International Conference on Design, Simulation, Manufacturing: The Innovation Exchange, DSMIE-2019, 85 (2019). doi:10.1007/978-3-030-22365-6_9
2. Luo J.C., Study on Stamping-Forging Process and Experiment of Sheet Metal Parts with Non-uniform Thickness. Wuhan: Huazhong University of Science & Technology, 51, 49 (2011)
Cited by
2 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献
1. Features of the Car Wheel Rims Manufacturing Technology for Electric Cars;2023 IEEE 5th International Conference on Modern Electrical and Energy System (MEES);2023-09-27
2. Electrotensiometry While Studying Plastic Deformation of Welded Cylindrical Samples;2023 IEEE 5th International Conference on Modern Electrical and Energy System (MEES);2023-09-27