Author:
Demianenko Maryna,Volf Michal,Banias Myron,Starynskyi Oleksandr
Abstract
During the operation of a gas compressor unit, the temperature of the exhaust system can cause failure or burnout of the inner facing sheets of the unit. The article describes a technique for determining the maximum temperature deformations of these elements. The technique enables more accurate calculation of the temperature deformations by determining the influence of the contacts between the inner facing and the power frame on the temperature distribution and mobility of the exhaust system. The temperature deformations and stresses of the exhaust system elements are determined, and the level of the permissible stresses is evaluated. The results of the work can be used to prevent possible ruptures and burning of the inner facing, as well as to calculate the design dimensions of the lens expansion joint.
Reference16 articles.
1. Poletaev A. and Nedoshivina A., “Investigation of characteristics and modernization of the design of exhaust tract gas turbine and gas compressors units”, Young scientists conference – 2017, UralENIN, «UrFU», pp. 123–124, 2017.
2. Lobanov A., Evaluation of the exhaust system dynamic loads of a gas compressor unit by vibroacoustic characteristics: PhD Thesis. Perm: PNPU, 135 p., 2008.
3. Baturin O., Krivcov A., Kolmakova D. and Matveev V., “Modeling, Analysis and Improvement of the Input Cleaning Device of a Gas Turbine Plant for Pumping Gas,” in Proceedings 2019 21st International Conference; Complex Systems: Control and Modeling Problems; CSCMP 2019, vol. 2019–September, pp. 365–369, 2019.
4. Numerical modeling of aeroelastic behavior of GTU centrifugal compressor rotor
5. Kyrylash O., Kostiuk V., Smirnov A., Tkachenko D., and Loboda I., Mathematical Simulation of the Gas Turbine Packages Thermal State, vol. Volume 5C: Heat Transfer. 2018.