Analysis of the applicability of die pressing method for ring-shaped parts fabrication-Reference-Cited by-同舟云学术

Analysis of the applicability of die pressing method for ring-shaped parts fabrication

Published:2018 Issue: Volume:224 Page:02074
ISSN:2261-236X
Container-title:MATEC Web of Conferences
language:
Short-container-title:MATEC Web Conf.

Author:

Lavrinenko Vladislav,Polyakova Anastasiya,Polyakov Artyom

Abstract

This paper analyses die pressing method used for fabrication of ring-shaped parts, which assures significant metal economy. Computer simulation results obtained with PAM-STAMP software are compared with experimental data. The research outcome is the established range of applicability of die-pressing method for manufacturing ring-shaped parts.

Publisher

EDP Sciences

Subject

General Medicine

Link

https://www.matec-conferences.org/10.1051/matecconf/201822402074/pdf

Reference4 articles.

1. Semenov Ye.I., Lavrinenko V.Yu., Ayrapetyan A.S., Demin M.V., Yastrebov Ye.I., Device for fabricating flat rings. RF Patent No 144991. Issued 10.09.2014. Bulletine No 25.

Cited by 7 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Development of the design technique of technological processes for manufacturing of ring-shaped parts by compression;Materials Today: Proceedings;2021

2. Development of Resource-Saving Technological Processes for Manufacturing Rings by the Compression Method;MATEC Web of Conferences;2021

3. Operational Effectiveness of Phase-Chronometric and Neurodiagnostic Methods for Controlling Rolling-Element Bearing Degradation;Measurement Techniques;2020-10

4. Thin sheet metal forming with composite material;IOP Conference Series: Materials Science and Engineering;2020-01-01

5. Efficiency of application of the phase-chronometric method and neurodiagnostics for monitoring the degradation of rolling bearings during operation;Izmeritel`naya Tekhnika;2020