Experimental Study on Truss-Column Pinned Connections in Large-Span Steel Structures-Reference-Cited by-同舟云学术

Experimental Study on Truss-Column Pinned Connections in Large-Span Steel Structures

Published:2022-06-20 Issue: Volume:2 Page:59-65
ISSN:2813-1002
Container-title:Engineering Innovations
language:
Short-container-title:EI

Author:

Ma Jianwei¹,Evangelista Ana¹,Haddad Assed Naked²^ORCID,Siddhpura Milind²,Hao Huifen³

Affiliation:

1. Deakin University

2. Universidade Federal do Rio de Janeiro

3. Kelley Covey Group

Abstract

A pin-connected joint, which was intended to accommodate a certain in-plane rotation and resist the shear forces, was introduced in this paper. Pinned-connections were applied on Truss-Column joints to support the heavy-loaded floors and roofs in a long-span steel structure. The Pinned-connection was designed in accordance with European code, and compared with other standards such as America standard and Australia standard. To better understand the behavior of materials and structure of this pin-connection structural system, four specimens, including two full-scale pin-connections and two truss connections, were tested to investigate the performance under both monotonic and cyclic loads. The load–displacement curves, hysteretic curve and ultimate loads were obtained, and the failure mode, capacity and ductility were discussed. The experimental and numerical results indicated that the pin-connection behaved good ductility, load transfer ability and capacity.

Publisher

Trans Tech Publications, Ltd.

Link

https://www.scientific.net/EI.2.59.pdf

Reference15 articles.

1. Ma, J.W., Chen Z, Hao H: Review of application of spherical plain bearing joints in steel structures. Building Structure, 2018, 48(23), p.92–100.

2. Li J.: Finite Element Calculation and Research of Typical Pin Shaft. Construction Mechanization, 2005,26(10):50-51.

3. Wand D.: The Application of ANSYS for Bearing Contact. Bearing, 2002(9):14-16.

4. Zhu Hao: The Research of Contact Forcedistribution of Pin Connection for Large Steel Structure Joint. Wuhan University of Technology, (2011).

5. Ding, D.Y: Experimental Study on Bearing Capacity of Beam-Column Pin Joints in Long-Span Steel Structure Under Heavy Load. Journal of Tianjin University:Science and Technology, 2015,48(Suppl):53-59.