Affiliation:
1. North Caucasus State Academy
2. Grozny State Oil Technical University named after Academician M.D. Millionshchikov
3. Chechen State Pedagogical University
Abstract
This article is devoted to expanding the technological capabilities of the gas-forming stamping method by increasing the pressure of combustion products acting on the surface of a workpiece stamped. Therefore, a scheme of a two-chamber device and a method for compressing the fuel mixture is proposed. The essence of the method is that of carrying out the stamping products under the high gas pressure, which is created by compression and subsequent combustion of the gaseous fuel mixture. To ensure the compression of the fuel mixture, the device is equipped with two combustion chambers separated by a piston. Due to this method, the pressure rises sharply. Under the influence of the combustion products' pressure, the workpiece is intensely deformed and fills the cavity of the matrix. This method of sheet stamping, implemented on a two-chamber device, will increase the gas pressure on the surface of the forged workpiece to 70-80 MPa at a fuel mixture pressure of 1 MPa, which ensures stamping of a variety range of parts in almost all branches of small-scale production related to metalworking.
Publisher
Trans Tech Publications, Ltd.
Subject
Mechanical Engineering,Mechanics of Materials,General Materials Science
Reference8 articles.
1. Stepanov VG, Shavrov IA 1975 High-energy pulse methods of metal processing. L.: Mechanical engineering, 280s.
2. Tohid Mirzababaie Mostofi, Hashem Babaei, Majid Alitavoli. Sep 2017 The influence of gas mixture detonation loads on large plastic deformation of thin quadrangular plates: Experimental investigation and empirical modeling. Article THIN WALL STRUCT.
3. Sandeep P. Patil, Madhur Popli, Vahid Jenkouk, Bernd Markert. Aug 2016 Numerical modeling of the gas detonation process of sheet metal forming. Article J Phys Conf.
4. Hashem Babaei, Tohid Mirzababaie Mostofi, Mojtaba Namdari-Khalilabad, Majid Alitavoli, Katayoun Mohammadi. Jun 2017 Gas mixture detonation method, a novel processing technique for metal powder compaction: Experimental investigation and empirical modeling. ArticlePOWDERTECHNOL.
5. Musaev AA 2012 Simulation of the working process of a two-chamber device for gas stamping, Proceedings of higher educational institutions. Mechanical engineering. No. 5. S.51-54.