Affiliation:
1. Pusan National University
2. Busan National University
Abstract
Die design rule for semi-solid die casting (SSDC) with A356 electromagnetic stirring (EMS) aluminum alloy, was proposed. The die design rule included inspection of machine, part requirements, parting line determination, sleeve, plunger, gating system, overflow, air vent, ejector pin, and heating line design. The specification of gating system, overflow, air vent, plunger tip, and sleeve suitable for respective part were regulated. Two steps die system of lower-positioned gate and
three steps die system of center-positioned gate were manufactured for 4 automobile suspension parts, based on the die design rule. For the sound filling pattern and solidification behavior, injection speeds of 4 parts were summarized to the interval (from V1 to V4). As a result of observing the microstructure of 4 parts after T6 heat treatment, primary Al-α phase was globularized and fine Si particles were distributed around the grain boundary. The mechanical properties of 4 parts with T6 heat treatment were investigated and showed ultimate tensile strength (UTS) of 330 MPa, yield strength (YS) of 250 MPa, and elongation of 7.5% as average.
Publisher
Trans Tech Publications, Ltd.
Subject
Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science
Reference7 articles.
1. Z. Fan: Inter. Mater. Rev. Vol. 47 (2) (2002), p.49.
2. D. Apelian: Proc. of the 6th Int. Conf. on Semi-Solid Processing of Alloys and Composites (2000), p.47.
3. P. Giordano, F. Boero, and G. Chiarmetta: Proc. of the 6th Int. Conf. on Semi-Solid Processing of Alloys and Composites (2000), p.29.
4. C.G. Kang and P. K Seo: J. of Mater. Proc. Tech. Vol. 135 (2003), p.144.
5. F. Bonollo et al.: Proc. of the 6th Int. Conf. on Semi-Solid Processing of Alloys and Composites (2000), p.137.
Cited by
10 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献