Affiliation:
1. Wuhan University of Technology
Abstract
In the present paper, a kind of Mo-Ti system functionally graded material with a continuous change of composition was formed via particle settling method at first, and then it was desified by hot-press under 1473K-30MPa-1h. Finally, by using an axisymmetric finite element method, the fabricated thermal stresses in a disk-shaped Mo-Ti FGM were calculated. The results showed that the thermal stresses changed continuously with the smooth variation of graded composition. The residual tensile stresses in the Mo-Ti FGM with a continuously changed composition were located in the medial region of graded layer and the radial compressive stresses distributed in the Mo- and Ti-rich sides. The calculated maximum residual tensile stresses in the Mo-Ti FGM were much lower than the bending strength of Mo-Ti alloys, which demonstrated that during fabrication no damages occurred in the Mo-Ti FGM with continuously graded composition.
Publisher
Trans Tech Publications, Ltd.
Subject
Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science
Reference12 articles.
1. Q. Shen, L.M. Zhang, H.P. Xiong, J.S. Hua, H. Tan: Chin. Sci. Bull. Vol. 45 (2000), p.1421.
2. H.P. Xiong, L.M. Zhang, Q. Shen, R.Z. Yuan: Trans. Nonferrous Met. Soc. China Vol. 9 (1999), p.582.
3. L.M. Zhang, J. Liu, R.Z. Yuan, T. Hirai: Mater. Sci. Eng. Vol. 203 (1995), p.272.
4. L.M. Zhang, R.Z. Yuan: J. Mater. Sci. Lett. Vol. 14 (1995), p.1620.
5. O. Kesler, J. Matejicek, S. Sampath, S . Suresh: Mater. Sci. Forum Vol. 308-311 (1998), p.389.
Cited by
4 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献